Abstract:This article proposes a modified deadbeat predictive current control (M-DPCC) method to improve the dynamic performance of permanent magnet synchronous motor (PMSM). Classical DPCC only predicts one control cycle of the PMSM, which restricts the dynamic performance since multiple control cycles are required for the transient state under heavy load and rated speed working condition. The proposed M-DPCC extends the single-step prediction to the entire dynamic interval in the transient state, by which the comprehensive optimization on the angle of the stator voltage vector can be implemented. Moreover, M-DPCC performed multi-step deadbeat calculation to keep the computation modest. To verify the effectiveness of the proposed M-DPCC, transient-state performance of PMSM using the M-DPCC method, the modulated model predictive control and classical DPCC are explored under a wide range of working condition. Comparative simulation and experimental results indicate that dynamic performance of the PMSM can be improved, especially under rated speed and heavy load conditions. Besides, the parameter sensitivity to inductance mismatch of the three methods is carried out. The stable operation range of the M-DPCC under inductance mismatch is larger than the other two methods. Moreover, the computation complexity of the three methods were investigated. The M-DPCC acquired less computation time than the modulated model predictive control.

High-Power-Factor Control Of Ipmsm Drive System With Small Dc-Link Capacitor

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Enhanced Inverter Current Control Method for Variable Frequency Drive System with Small Film DC-Link Capacitor

An Active Damping Method for IPMSM Drive with Small Film DC-Link Capacitor Based on Rectifier Side Current Reconstruction

Admittance Reshaping Based on Adaptive Minimum Value of DC-Link Voltage for IPMSM Drive with Small Film Capacitor

Control Method of PMSM Driving System with Small DC-Link Capacitor

Power Perturbation Based Virtual Signal Injection Control of MTPA for IPMSM Drive System

A Robust Deadbeat Predictive Current Control Method for IPMSM

A Modified Deadbeat Predictive Current Control with Improved Dynamic Performance under Insufficient Voltage Margin for IPMSM

High-Order Band-Pass Active Damping Control and Predictive Control for Three-Phase Small-Film DC-Link Capacitor IPMSM Drive Systems

Stability Improvement of V/f Control Scheme with Active Damping for Small Capacitor IPMSM Drive System

Improved Model Predictive Current Control for PMSM Drives Based on Dynamic Reference Current

Maximum Torque Per Ampere Control of IPMSM Based on Online Parameter Identification Considering Cross-coupling and Saturation Effects

An I/f Control Method With Closed-loop Regulation of Current Vector for Surface Permanent Magnet Synchronous Motor Drives

Control Strategy of High Performance IPMSM Drive in Wide Speed Range

A Deadbeat Predictive Current Harmonics Suppression Method for IPMSM Based on Quasi Proportional Resonant Control

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

Control of Interior Permanent Magnet Synchronous Motor Drives over a Wide Speed Range

A Virtual Signal Injection Based MTPV Control for IPMSM

Simplified PWM for Fault Tolerant Control of Open Winding PMSM Fed by Hybrid Inverter