Abstract:The motor drive has been widely adopted in modern power applications. With the emergency of the next generation wide bandgap semiconductor device, such as silicon carbide (SiC) MOSFET, performance of the motor drive can be improved in terms of efficiency, power density, and reliability. However, the fast switching transient and serious switching ringing of the SiC MOSFET can cause unwanted high-frequency (HF) electromagnetic interference (EMI), which may significantly reduce the reliability of the motor drive in many aspects. In order to comprehensively reveal the mechanism of the EMI previously used in motor drives using SiC MOSFET, this paper plans to analyze the influences of both HF impedance of the motor and switching characteristics of the SiC MOSFET. A simulation model for motor drives has been proposed, which contains the HF circuit model of the motor as well as a semi-behavioral analytical model of the SiC MOSFET. Since the model shows a good agreement with the experimentally measured results on spectra of drain-source voltage of the SiC MOSFET (vds), phase to ground voltage of the motor (vphase), CM voltage (vcm), phase current of the motor (idm), and CM current (icm), it can be adopted to quantitatively investigate the influence of the motor impedance on EMI through frequency-domain analysis. Additionally, the impacts of switching characteristics of SiC MOSFET on EMI are also well studied according to relative experiment results in terms of switching speed, switching frequency, and switching ringing. Based on the analysis above, the relationship between motor impedance, switching characteristics of the SiC MOSFET, and HF EMI can be figured out, which is able to provide much helpful assistance for application of the motor drive.

Efficient protection and control of electric drives using solid state circuits

Study On The Protection Of Asymmetric Bridge Circuit For Switched Reluctance Motor

A Review of Electronic Inductor Technique for Power Factor Correction in Three-Phase Adjustable Speed Drives

A Compact Gate Control and Voltage-Balancing Circuit for Series-Connected SiC MOSFETs and Its Application in a DC Breaker

A Single Gate Driver Based Solid-State Circuit Breaker Using Series Connected SiC MOSFETs

A High-Efficiency Protection Circuit Integrating Semi-Soft Switching and Voltage Limiting Functions for Solid-State Switch Applications

Hardware implementation of reliable designs for full SiC inverter-fed motor drive systems

Independent Current Control of Dual Parallel SRM Drive Using a Public Current Sensor

Implementation of Phase-sensitive Protection of Mine-used Motor Based on Single-chip Microcomputer

Design Of Comprehensive Motor Protector Based On Improved Sliding-Window Iterative Dft Algorithm

Active Stator Winding Thermal Protection for AC Motors

Adaptive Control of Surge Impedance for Electric Motors in Motor Drive Systems

Asynchronous Modular Contactor for Intelligent Motor Control Applications

A Novel Safe Shutdown Strategy for Matrix Converter Even under Fault Condition

Advanced gate driving concepts and switching optimization for SiC semiconductors

Modeling and Experimental Investigation of Electromagnetic Interference (EMI) for SiC-Based Motor Drive

A DC Signal Injection-Based Thermal Protection Scheme for Soft-Starter-Connected Induction Motors

A SiC JFET-Based Solid State Circuit Breaker With Digitally Controlled Current-Time Profiles

Method of drive and rapid protection for high power IGBTs

Design of High Reliable Electromechanical Actuator Controller Based on Integrated Drive Module

A Systematic Approach to Digital Control Development for Four-Phase SRM Drive Using Single Current Sensor for Medium Power Applications