Abstract:Robotic tasks often exceed the scope of steady-state or periodic behavior, which necessitates generally-applicable models of actuators intended to generate transient or aperiodic motion. However, existing electromechanical models of servomotors typically omit consideration of the switching power converter circuits required for directional, speed, or torque control. In this study, a multi-domain framework is established for switched electromechanical dynamics in servomotor systems for their analysis and control in general aperiodic tasks including transient phases. The switched electromechanical dynamics is derived from the individual models of the internal DC motor, gear train, and H-bridge circuit. The coupled models comprehensively integrate all possible distinct switching configurations of on-state, off-state, and dead time. A combination of cycle averaging with piecewise analytical solutions of the non-smooth dynamics is introduced to handle different temporal scales from high-frequency electrical to low-frequency mechanical variables. System parameters were estimated from experimental data using a dual-servomotor test platform. The model was validated for predictive accuracy against measured data in two distinct tasks-dynamic braking of a pendulum system and sinusoidal trajectory following. The model was also used to formulate the servomotor power consumption, which was implemented for optimal control demonstration and energy analysis. In particular, the servomotor power consumption model provided true optimality (minimization) when compared with the squared rotor torque and the positive rotor mechanical power that are commonly used as proxy models. While the focus of this work is on permanent-magnet, armature-controlled brushed DC servomotors, the approach is applicable to general electromechanical systems with switching-based control.

Asynchronous Modular Contactor for Intelligent Motor Control Applications

Study on Switching Strategy of PMSM and BLDCM

Design ＆ Implementation of an Energy Saver IC for AC Contactor

Design and Torque Optimization of Single-phase Hybrid Switched Reluctance Motors

Design of A Novel Hybrid Non-Contacted Switch

Adaptive Contactor – A New Scheme to Improve Induction Motor Immunity to Voltage Sags

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Material performance analysis and structure design of the A.C. contactor driven by MSMA

Modular Full-Bridge Converter for Three-Phase Switched Reluctance Motors With Integrated Fault-Tolerance Capability

Control and Modulation of a Single-Phase AC/DC Converter with Smooth Bidirectional Mode Switching and Symmetrical Decoupling Voltage Compensation

Power Electronic Load System for Motor Drivers Testing Considering Motor Faulty Status Simulation

DC-bus Voltage Control Strategy of DSTATCOM Using Modulation-Ratio-regulation for Start-Up Process

Low-Cost Direct Instantaneous Torque Control for Switched Reluctance Motors with Bus Current Detection under Soft-Chopping Mode

Design of Soft Start Energy-Saving Controller of Asynchronous Motor

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

Two-Level Excitation Current Driver to Reduce the Driving Power of an Electromagnetic Contactor

A Controlled Mechanical–Electronic Hybrid Commutation Theory and Position Sensorless Control

Robust Commutation Design: Applied to Switched Reluctance Motors

Development of a digital control system for a belt-driven starter generator segmented switched reluctance motor for hybrid electric vehicles

Switched electromechanical dynamics for transient phase control of brushed DC servomotor

Computationally Efficient Overmodulation Methods for Synchronous Motor Drive Systems