Abstract:Moisture condensation may cause degradation of key motor components when a motor is de-energized. To prevent moisture condensation, a motor's temperature must be maintained higher than the ambient temperature when de-energized. This paper proposes a non-intrusive motor heating technique using soft-starters. By controlling the operation of the solid-state switches in soft-starters, adjustable ac current can be injected into the three phases of the stator windings without inducing any output torque. The motor temperature can therefore be maintained at a desired temperature due to the heat dissipation during current injection. In addition, two motor temperature control approaches are proposed in this paper to minimize the required energy consumption for preventing moisture condensation. The proposed technique is experimentally validated on a 7.5-hp ODP (open drip proof) induction motor. The experimental results show that the average stator winding temperature can reaches 9° above the ambient temperature with acceptable current magnitudes. In addition, it is shown that the motor temperature rise can be controlled by adjusting the operation of the solid-state switches in soft-starters. The importance of the proposed technique lies in its non-invasive nature: the technique only uses the existing hardware of soft-starters; the motor's condition is not interrupted since no output torque is induced during the current injection. The proposed winding heating technique can be easily extended to other types of ac machines or inverter-fed applications.

Design of Soft Start Energy-Saving Controller of Asynchronous Motor

A Novel Adaptive Commutation Angle Method for Single Phase BLDC Motor

Low Cost Control Method for Brushless DC Motors Based on Fuzzy Logic Controller

Design and Torque Optimization of Single-phase Hybrid Switched Reluctance Motors

Design on Soft-starting and Protection Controller for Asynchronous Motor Based on Microprocessor AT89C52

Study of Soft Starting Controller with High Performance and Low Cost

Electromagnetic Performance Analysis and Optimization of Asynchronous Motors Based on Finite Element Analysis

Application of Fuzzy-PI Controller in the Asynchronous Motor

Soft Start Control of Large-Capacity Synchronous Motor

Adaptive Soft-Switching Control of Active-Clamping Three-Phase Inverters

Design of Industrial Sewing Control System of Energy-Saving Motor Based on DSP

Application Analysis of Frequency-variable and Speed-regulative Motor

Optimum Design of Switched Reluctance Motor Based on Direct Instantaneous Torque Control

Research on an AC Variable-frequency Power Dynamometer Based on PWM Rectifier and Fuzzy Direct Torque Control

Low-Cost Direct Instantaneous Torque Control for Switched Reluctance Motors with Bus Current Detection under Soft-Chopping Mode

The Application of Volt-Booster Transformer as a Part of Asynchronous Motors Control Devices

Modeling and Optimization of Soft Start-Up for Hydroviscous Drive Applied to Scraper Conveyor

A novel power quality improved AC voltage controller for soft starting of squirrel cage induction motors

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

A Non-Intrusive Winding Heating Method for Induction Motor Using Soft-Starter for Preventing Moisture Condensation

The Seamless Transition From Discrete Frequency Control to Phase Control Method Using Soft Starter