Abstract:The Ge surfaces were cleaned and passivated by two kinds of chemical pretreatments: conventional combination of HF + (NH4)(2)S, and new one of HBr + (NH4)(2)S. The chemical states and stability at passivated Ge surfaces were carefully characterized. The influence of chemical surface treatments on the interface and electrical properties of Al2O3 gate dielectric films on Ge grown by atomic layer deposition (ALD) has been investigated deeply. It is found that the combination of HBr and (NH4)(2)S can remove more Ge-O bonds on the Ge surface compared to that of conventional HF and (NH4)(2)S with excellent stability. X-ray photoelectron spectroscopy (XPS) reveals that HBr and (NH4)(2)S treated Ge surface has a mixture states of GeOx (9.25%) and GeS (7.40%) while HF and (NH4)(2)S treated Ge surface has a mixture states of GeOx (16.45%) and GeS (3.37%). And the Ge-S peak from the surface of Ge substrates decreases a little after the HBr and (NH4)(2)S treated Ge surface was exposed in the ambient for 300 min, which suggests the Ge surface is stable to oxidants. The Al2O3 films on HBr and (NH4)(2)S treated Ge substrates exhibits better electrical properties such as large capacitance, decreased leakage current density by similar to two orders of magnitude, and less C-V hysteresis. This indicates that a reduction in charge traps possibly at the interface and more interface traps are terminated by sulfur. The surface treatment of HBr and (NH4)(2)S seems to be very promising in improving the quality of high-k gate stack on Ge substrates. (C) 2010 Elsevier B.V. All rights reserved.

Effective Method for Preparation of Oxide-Free Ge2sb2te5 Surface: an X-Ray Photoelectron Spectroscopy Study

The Characterization and Preparation of Nano-Scale Fe Doping Tio2 by Sol-Gel Method (I) - the Crystallization and Thermal Decomposition Process of Fe Doping Tio2 Xerogel Powders Using Thermal Tg-Ir Spectrometry

Oxidation and Oxygen Thermal Desorption Mechanism on Narrow-Gap Iv-Vi Semiconductor Pbte(111) Surface

Development of procedures for obtaining clean, low-defect-density Ge(100) surfaces

Study of Surface Oxidation of PbTe Films

Atomic Layer-By-Layer Oxidation Of Ge (100) And (111) Surfaces By Plasma Post Oxidation Of Al2o3/Ge Structures

The Surface Tension of Ga2O3 Melt Measured by a Drop-Weight Method in an Optical Floating-Zone Furnace

Silicon Doping Effect on the Crystallization Behavior of Ge2Sb2Te5 Film

Termination of Single Crystal Bi2Se3 Surfaces Prepared by Various Methods

Surface preparation and wet cleaning for Germanium surface

Formation of Ge-S bonds from AOT-coated GeO2 nanoparticles at high temperature: An in situ heating EXAFS investigation

Preparation of atomically-flat SrTiO3 surfaces using a deionized-water etching and thermal annealing procedure

Effect of Chemical Surface Treatments on Interfacial and Electrical Characteristics of Atomic-Layer-deposited Al2O3 Films on Ge Substrates

Preparation of clean surfaces and Se vacancy formation in Bi$_{2}$Se$_{3}$ by ion bombardment and annealing

Etching of elemental layers in oxide molecular beam epitaxy by O2-assisted formation and evaporation of their volatile suboxide: The examples of Ga and Ge

Effect of Preparation Method on the Surface and Redox Properties of Ce0.67zr0.33o2 Mixed Oxides

The Environmental Stability Characterization of Exfoliated Few-Layer CrXTe3 (X = Si, Ge) Nanosheets

Preparation and characterization of high specific surface area Ce 0.5Zr0.5O2 mixed oxide

Elemental Diffusion Study of Ge/Al2O3 and Ge/AlN/Al2O3 Interfaces Upon Post Deposition Annealing

Gaas Surface Wet Cleaning by A Novel Treatment in Revolving Ultrasonic Atomization Solution

Surface Oxidation of the Topological Insulator Bi2Se3