Abstract:This paper introduces a digital interface application-specific integrated circuit (ASIC) for a micro-electromechanical systems (MEMS) vibratory gyroscope. The driving circuit of the interface ASIC uses an automatic gain circuit (AGC) module instead of a phase-locked loop to realize a self-excited vibration, which gives the gyroscope system good robustness. In order to realize the co-simulation of the mechanically sensitive structure and interface circuit of the gyroscope, the equivalent electrical model analysis and modeling of the mechanically sensitive structure of the gyro are carried out by Verilog-A. According to the design scheme of the MEMS gyroscope interface circuit, a system-level simulation model including mechanically sensitive structure and measurement and control circuit is established by SIMULINK. A digital-to-analog converter (ADC) is designed for the digital processing and temperature compensation of the angular velocity in the MEMS gyroscope digital circuit system. Using the positive and negative diode temperature characteristics, the function of the on-chip temperature sensor is realized, and the temperature compensation and zero bias correction are carried out simultaneously. The MEMS interface ASIC is designed using a standard 0.18 μM CMOS BCD process. The experimental results show that the signal-to-noise ratio (SNR) of sigma-delta (ΣΔ) ADC is 111.56 dB. The nonlinearity of the MEMS gyroscope system is 0.03% over the full-scale range.

Design of the Micromachined Gyroscope Interface ASIC

Designing of a Micromachined Gyroscope System with a Closed-Loop DC Biased Interface ASIC

An Interface ASIC Design of MEMS Gyroscope with Analog Closed Loop Driving

A Bulk Micromachined Gyroscope With Improved Quality-Factors At Atmospheric Pressure

An Interface ASIC for MEMS Vibratory Gyroscopes with Nonlinear Driving Control

High Performance Interface Circuit for MEMS Gyroscope

A Low-Noise High-Linearity Interface ASIC for MEMS Gyroscopes

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

A Digital Interface ASIC for Triple-Axis MEMS Vibratory Gyroscopes

The design of interface ASIC based on ring Schottky diode for MEMS gyroscope

A low-noise SC-type interface asic for a closed-loop MEMS gyroscope

Integrated bulk-micromachined gyroscope using deep trench isolation technology

A High-Voltage Interface Circuit for MEMS Vibratory Gyroscope

A Low-noise High-voltage Interface Circuit for Capacitive MEMS Gyroscope.

An Interface ASIC for an Atmospheric-Pressure MEMS Gyroscope with PLL-Based Phase Adjustment and SC Amplitude Regulation

A Low-Noise HV Interface Circuit for MEMS Vibratory Gyroscope

The design and implementation of interface electronics for silicon micromechanical gyroscopes

Research on a Silicon Gyroscope Interface Circuit Based on Closed-Loop Controlled Drive Loop

A Dual-Axis MEMS Vibratory Gyroscope ASIC with 0.0061°/s/vhz Noise Floor over 480 Hz Bandwidth

A Low-Noise Interface ASIC for MEMS Disk Resonator Gyroscope

A Bulk Micromachined Z-Axis Single Crystal Silicon Gyroscope for Commercial Applications