Abstract:High-precision microelectromechanical system (MEMS) accelerometers have wide application in the military and civil fields. The closed-loop microaccelerometer interface circuit with switched capacitor topology has a high signal-to-noise ratio, wide bandwidth, good linearity, and easy implementation in complementary metal oxide semiconductor (CMOS) process. Aiming at the urgent need for high-precision MEMS accelerometers in geophones, we carried out relevant research on high-performance closed-loop application specific integrated circuit (ASIC) chips. According to the characteristics of the performance parameters and output signal of MEMS accelerometers used in geophones, a high-precision closed-loop interface ASIC chip based on electrostatic time-multiplexing feedback technology and proportion integration differentiation (PID) feedback control technology was designed and implemented. The interface circuit consisted of a low-noise charge-sensitive amplifier (CSA), a sampling and holding circuit, and a PID feedback circuit. We analyzed and optimized the noise characteristics of the interface circuit and used a capacitance compensation array method to eliminate misalignment of the sensitive element. The correlated double sampling (CDS) technology was used to eliminate low-frequency noise and offset of the interface circuit. The layout design and engineering batch chip were fabricated by a standard 0.35 μm CMOS process. The active area of the chip was 3.2 mm × 3 mm. We tested the performance of the accelerometer system with the following conditions: power dissipation of 7.7 mW with a 5 V power supply and noise density less than 0.5 μg/Hz1/2. The accelerometers had a sensitivity of 1.2 V/g and an input range of ±1.2 g. The nonlinearity was 0.15%, and the bias instability was about 50 μg.

The design of interface ASIC based on ring Schottky diode for MEMS gyroscope

Analysis of Temperature Characteristic and Design of Interface ASIC Based on Ring Schottky Diode for MEMS Gyroscope

An Interface ASIC Design of MEMS Gyroscope with Analog Closed Loop Driving

High Performance Interface Circuit for MEMS Gyroscope

An Interface ASIC for MEMS Vibratory Gyroscopes with Nonlinear Driving Control

A low-noise SC-type interface asic for a closed-loop MEMS gyroscope

A High-Voltage Interface Circuit for MEMS Vibratory Gyroscope

A Low-Noise High-Linearity Interface ASIC for MEMS Gyroscopes

A Low-Noise Interface ASIC for MEMS Disk Resonator Gyroscope

A Novel Amplitude-Phase Information Extraction Architecture for MEMS Vibratory Gyroscopes Using a Modified Double Side-Band Demodulation Configuration

Designing of a Micromachined Gyroscope System with a Closed-Loop DC Biased Interface ASIC

A Digital Interface ASIC for Triple-Axis MEMS Vibratory Gyroscopes

An Interface ASIC for an Atmospheric-Pressure MEMS Gyroscope with PLL-Based Phase Adjustment and SC Amplitude Regulation

A Low-Noise HV Interface Circuit for MEMS Vibratory Gyroscope

A Low-noise High-voltage Interface Circuit for Capacitive MEMS Gyroscope.

An Improved Phase Lock Loop for Micromechanical Gyroscope with A Carrier Modulation

Design and Test of MEMS Gyroscope Control System Based on LMSD

Design of an interface circuit system for mode-separation MEMS digital gyroscope

Research on High-Resolution Miniaturized MEMS Accelerometer Interface ASIC

Design of SoC for Special Measurement and Control of MEMS Gyroscope Based on ARM Cortex-M3

Research on the ring-diode based readout circuit for MEMS vibratory gyroscopes