Abstract:State-of-the-art endoscopy systems require electronics allowing for real-time, bidirectional data transfer. Proposed are 2.4-GHz low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications. The prototype integrates a low-IF receiver analog front-end [low noise amplifier (LNA), double balanced down-converter, bandpass-filtered automatic gain controlled (AGC) loop and amplitude-shift keying (ASK) demodulator], and a direct up-conversion transmitter analog front-end [20-MHz IF phase-locked loop (PLL) with well-defined amplitude control circuit, ASK modulator, up-converter, and power amplifier] on a single chip together with an internal radio frequency oscillator and local oscillating (LO) buffers. Design tradeoffs have been made over the boundaries of the different building blocks to optimize the overall system performance. All building blocks feature circuit topologies that enable comfortable operation at low power consumption. The circuits have been implemented in a 0.25-microm CMOS process. The measured sensitivity of the receiver analog front-end is -70 dBm with a data rate of 256 kbps, and the measured output power of the transmitter analog front-end could achieve -23 dBm with a data rate of 1 Mbps. The integrated circuit consumes a current of 6 mA in receiver mode and 5.6 mA in transmitter mode with a power supply of 2.5 V. This paper shows the feasibility of achieving the analog performance required by the wireless endoscopy capsule system in 0.25 microm CMOS.

A 7.2mw 15mbps Ask Cmos Transmitter For Ingestible Capsule Endoscopy

A Low-Power, High Data-Rate CMOS ASK Transmitter for Wireless Capsule Endoscopy

A 2.4ghz Low Power ASK Transmitter for Wireless Capsule Endoscope Applications

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A 5.9mw 50mbps CMOS QPSK/O-QPSK Transmitter Employing Injection Locking for Direct Modulation

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

Low Power Transmitter for Capsule Endoscope

A 2.4ghz Low Power Wireless Transceiver Analog Front-End for Endoscopy Capsule System

Low Power High Data Rate Wireless Endoscopy Transceiver.

A SoC with 3.9mW 3Mbps UHF transmitter and 240μW MCU for capsule endoscope with bidirectional communication

An ASK-Based IF Receiver for Wireless Endoscopy Capsule Systems

A 50-Mb/s CMOS QPSK/O-QPSK Transmitter Employing Injection Locking for Direct Modulation

An Asymmetrical QPSK/OOK Transceiver SoC and 15: 1 JPEG Encoder IC for Multifunction Wireless Capsule Endoscopy.

A 13 pJ/bit 900 MHz QPSK/16-QAM Band Shaped Transmitter Based on Injection Locking and Digital PA for Biomedical Applications

A 20Mbps 5.8mw QPSK transmitter based on injection locking and Class-E PA for wireless biomedical applications

Low-power transceiver analog front-end circuits for bidirectional high data rate wireless telemetry in medical endoscopy applications

A 9.4 Pj/bit 432 MHz 16-QAM/MSK Transmitter Based on Edge-Combining Power Amplifier

An efficient wireless power transmission system for the capsule endoscopy applicaton

Low Power Ultra-Wideband Wireless Telemetry System for Capsule Endoscopy Application

A 400MHz/900MHz Dual-Band Ultra-Low-Power Digital Transmitter for Biomedical Applications

A Wireless Capsule Endoscope System with Low-Power Controlling and Processing ASIC