Abstract:A fibrocartilaginous tissue develops in tendon at the point where the tendon wraps under bone and is subjected to transverse compressive loading in addition to tension. This tissue is characterized by a high level of large proteoglycan (aggrecan), which could accumulate because of increased synthesis, diminished turnover, or both. To examine the effect of loading on proteoglycan turnover segments of fetal tendon in sterile culture were subjected to cyclic, uniaxial compression loading to 30% of initial thickness once every 6 sec. for 72 h, and then allowed to incorporate 35S-sulfate for 12 h. The rate of loss of newly-synthesized 35S-proteoglycans from tissue was determined during subsequent culture for up to 12 days, with or without continued loading. Proteoglycan was lost from fetal tendon segments rapidly during the first 3 days of culture and slowly thereafter. Loss of newly-synthesized proteoglycan from adult tendon fibrocartilage was linear, with a half life of 12 d. Segments of fetal tendon subjected to cyclic compression before labeling synthesized more proteoglycan. These segments lost a greater percent of labeled proteoglycan to medium during a subsequent 12-day culture period than matched segments that had not experienced loading. Analysis of medium and tissue proteoglycans by SDS polyacrylamide gel electrophoresis and sieve chromatography indicated that small proteoglycans (decorin and biglycan) were retained in both loaded and non-loaded tissue whereas large proteoglycans (migrating in the Vo of a Sepharose CL-4B column) were readily lost. It is concluded that the 3-day loading regimen did not diminish turnover of large proteoglycan. To the contrary, although synthesis of large proteoglycan was enhanced by the loading regimen, these proteoglycans were still rapidly lost from the fetal tissue.

The thermal fatigue resistance of cast iron with biomimetic non-smooth surface processed by laser with different parameters

INTEGRATED TECHNOLOGY FOR DETECTION AND REPAIR OF MECHANICAL COMPONENT SURFACE FATIGUE MICROCRACKS USING PULSED LASER

Fatigue Crack Propagation in Laser Alloyed Ductile Cast Iron Surface

Metallographic study of laser thermal fatigue damage on piston

The comparative study of thermal fatigue behavior of laser deep penetration spot cladding coating and brush plating Ni–W–Co coating

PREVENTION and TREATMENT of postoperative ATELECTASIS: RESULTS IN 2478 CASES

Crack resistance and wear resistance of laser clad layer on the surface of cast iron

Study on the effects of laser quenching power and scanning speed on the property of cast iron

Research on the Thermal Fatigue Mechanism of Laser Cladding IN625 Process on Ductile Iron

Treatment of Discrepancy in Leg Length

Bionic Laser Surface Remelting for the Wear Performance after Thermal Fatigue of B2 Die Steel Based on Surface Stress Simulation

Numerical Simulation and Mechanism Analysis of Thermal Fatigue Crack for Low-Alloy Steel Brake Disc of High-Speed Train

Influence of varying distribution distance and angle on fatigue wear resistance of 40Cr alloy steel with laser bionic texture

Thermal fatigue crack growth behavior of ZCuAl10Fe3Mn2 alloy strengthened by laser shock processing

Biomimetic approach in surface modification for improvement in the mechanical properties of implements

Crack Growth Behavior at Thermal Fatigue of H13 Tool Steel Processed by Laser Surface Melting

Quantitative analysis and experimental study of the influence of process parameters on the evolution of laser cladding

The effect of compressive loading on proteoglycan turnover in cultured fetal tendon.

Effect of Composition on the Mechanical Properties and Wear Resistance of Low and Medium Carbon Steels with a Biomimetic Non-Smooth Surface Processed by Laser Remelting

Microstructure and mechanical properties of composite strengthened high-chromium cast iron by laser quenching and laser shock peening

Effects of laser shock processing, solid solution and aging, and cryogenic treatments on microstructure and thermal fatigue performance of ZCuAl10Fe3Mn2 alloy