Abstract:Direct Laser Writing (DLW) using ultrashort pulsed lasers and galvanometer scanning, has become an established process for surface texturing, allowing an extensive variety of feature geometries and texture designs to be produced. The minimum feature sizes that can be generated are however limited by factors such as the laser output power, beam diameter, beam wavelength and associated optics. To address the need to produce even smaller texture features, Direct Laser Interference Patterning (DLIP) has been developed, which utilises bespoke beam splitting and converging optics to produce periodic interference fringing and enabling surface textures in the micrometric size range to be produced. In this study, the texturing of cast iron cylinder liner segments using DLW and DLIP processes is explored, to assess their tribological performance in high efficiency internal combustion engines, such as for hybrid applications. To facilitate the designs of textures and to capture high resolution data on surface interactions at specific points in the combustion cycle, the segmentation of cylinder lines and piston rings is undertaken. The results of tribology tests covering combinations of high and low speeds and contact pressures, have shown that the mechanical honing of cylinder liners could potentially be replaced with the cleaner DLIP texturing as an alternative. Optimised texture designs using the DLW process achieved up to a 54 % reduction in kinematic friction between the piston ring and textured cylinder liner surfaces, compared with mechanically honed cylinder liner segments. These results have indicated that DLW texturing offers the best improvement in friction performance in the boundary and mixed lubrication regimes at higher contact pressures, at both lower and higher sliding speeds. The results also provide useful comparative data on the performance of meso and micrometric scale textures and how they can be best applied to cylinder liners.

Biomimetic approach in surface modification for improvement in the mechanical properties of implements

Bio-inspired Wearable Characteristic Surface: Wear Behavior of Cast Iron with Biomimetic Units Processed by Laser

Frictional Wear and Thermal Fatigue Behaviours of Biomimetic Coupling Materials for Brake Drums

The friction of surface textured cylinder liner segments modified by Direct Laser Writing and Direct Laser Interference Patterning processes

Thermal Fatigue Behavior of Gray Cast Iron with Striated Biomimetic Non-Smooth Surface

Effect of Medium on Friction and Wear Properties of Compacted Graphite Cast Iron Processed by Biomimetic Coupling Laser Remelting Process

The Preparation of Biomimetic Nano-Al2o3 Surface Modification Materials on Gray Cast Iron Surface

Microstructure and Soil Wear Resistance of a Grey Cast Iron Alloy Reinforced with Ni and Cr Laser Coatings

Surface Texturing for Low Friction Mechanical Components

Effect of Surface Melting and Chromium Surface Alloying on Wear Behavior of Ductile Iron

Improving Tribological Performance of Mechanical Components by Laser Surface Texturing

Investigation of the Tribological Behaviour of Various AMC Surfaces against Brake Lining Material

Friction and Wear Behaviors of Compacted Graphite Iron with Different Biomimetic Units Fabricated by Laser Cladding

Effects of C content on the thermal fatigue resistance of cast iron with biomimetic non-smooth surface

Wear Behavior of Medium Carbon Steel with Biomimetic Surface under Starved Lubricated Conditions

Bionic Laser Surface Remelting for the Wear Performance after Thermal Fatigue of B2 Die Steel Based on Surface Stress Simulation

Microstructural Properties of Particle-Reinforced Multilayer Systems of 316L and 430L Alloys on Gray Cast Iron

Experimental Investigations on Microstructure, Mechanical and Wear Behavior Under Dry Sliding of Al6061 with Particulate-Reinforced SiC and TiB2 Metal Matrix Composite Developed by Stir Casting

Improving the Properties of Gray Cast Iron by Laser Surface Modification

On the Efficiency of Laser Alloying of Grey Cast Iron with Tungsten and Silicon Carbides

Improving the Abrasion Resistance of Nodular Cast Iron Castings by Remelting Their Surfaces by Laser Beam