Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Seebeck Coefficient and Thermal Conductivity in Doped C-60

Doped C 60 Study from First Principles Simulation

Enhanced Thermoelectric Properties in Highly Co-Doped Bi2Se3 by Density-of-State Effective Mass Increase

Boosting the Seebeck Coefficient for Organic Coordination Polymers: Role of Doping-Induced Polaron Band Formation.

Doping Effects on Internally Coupled Seebeck Coefficient, Electrical, and Thermal Conductivities in Aluminum-Doped Tio2

Determining doping efficiency and mobility from conductivity and Seebeck data of n-doped C60 layers

Superconductivity in Sn-Doped C-60

Enhanced Thermoelectric Performance of N-Type PbTe Through the Introduction of Low-Dimensional C60 Nanodots

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Effect of Co-Doping on Thermoelectric Properties of n-Type Bi2Te3 Nanostructures Fabricated Using a Low-Temperature Sol-Gel Method

Thermoelectric Properties of Ho-doped Bi1-xSbx

Thermoelectric Properties of Homogeneously and Non-Homogeneously Doped CdTe15/16M1/16 (M=N, P, As, Sb) and Cd15/16TeM1/16 (m=na, K, Rb, Cs)

The Influence of Silicon Dopant and Processing on Thermoelectric Properties of B4C Ceramics

Co-doping for Significantly Improved Thermoelectric Figure of Merit in P-Type Bi1-2xMgxPbxCuSeO Oxyselenides

In Situ Conductivity Study of the Phase Transition in Sb-doped C60

Enhanced Thermoelectric Properties of Bi2Sr2Co2Oy by Alkali Metal Element Doping and SiC Dispersion

Electronic Transport Properties in Doped C-60 Molecular Devices

Effects of Bi Doping on the Thermoelectric Properties of Beta-Zn4sb3

High Thermoelectric Performance of Ge1−xPbxSe0.5Te0.5 Due to (pb, Se) Co-Doping

Trace bismuth and iodine co-doping enhanced thermoelectric performance of PbTe alloys

Thermoelectric Properties of Mechanically-Alloyed and Hot-Pressed Cu12−xCoxSb4S13 Tetrahedrites