Abstract:High temperature corrosion has become one of the leading causes of boiler waterwall tube failures because of the wide application of air-staged combustion in coal-fired boilers. High temperature corrosion is strongly affected by the H 2 S concentration and wall tube temperature distributions in the furnace. Particularly, the corrosion rate increases exponentially with the increase of tube temperature. However, by far most of the numerical studies on high temperature corrosion only considered the effects of H 2 S concentration while the critical effects of tube temperature were overlooked. Thus, this paper presents a comprehensive corrosion model that incorporates the key effects of both tube temperature and H 2 S concentration. Specifically, the tube temperature is predicted by a coupled combustion and hydrodynamic model that integrates the critical effects of both the boiler gas flow and steam flow on waterwall tube temperature. The H 2 S concentration is predicted by a sulfur evolution model describing the devolatilization process of coal sulfur species and their subsequent gaseous reactions. The tube temperature prediction model and H 2 S evolution model provide all the key parameters for accurate prediction of boiler waterwall corrosion. The corrosion model is applied to a 350 MW supercritical wall-fired boiler. The results show that the tube temperature varies significantly over the boiler waterwall, and hence, has significant impacts on the distribution of wall tube corrosion. Particularly, local high tube temperature zones could form on the waterwall areas of relatively low H 2 S concentration leading to substantially higher tube corrosion rates than the adjacent wall areas. The results demonstrate the importance of incorporating both the wall tube temperature and H 2 S concentration in the prediction of boiler waterwall corrosion.

Theoretical Model for Wall Temperature of the High-speed Air-cooled Single-tube and the Experimental Verification

Experimental Study on the Influence of Slagging and Fouling for Wall Temperature Distribution

Mathematical model on heat flux analysis of water wall in 1000MW USC boiler furnace combustion zone

Model Validation and Simulation Studies on Zoned and Staged Gas Fired Radiant Tubes

Analysis of Temperature Distribution and Influence Factors for Water-Cooled Wall Gasifier

A Dynamic Heat Transfer Model to Estimate the Flue Gas Temperature in the Horizontal Flue of the Coal-Fired Utility Boiler

Experimental and Numerical Analysis of Temperature Distribution on Floating-Wall Flame Tube of Combustor

Numerical investigation of boiler waterwall corrosion by integrated tube temperature prediction and sulfur evolution model

Experimental investigation on the wall temperature characteristics and critical heat flux in a horizontal v-shaped tube

The Experiment Study on Resolving the High-temperature Erosion of Water Cooled Wall in Power Plant Boiler

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Numerical Simulation and Experimental Study on Radiation Heat Transfer in Flame Tube

Temperature Simulation and Testing for the Layered Tube Wall in Heat Load

Experimental Verification and Improvement of Heat Transfer Tube Local Wall Temperature Measurement Method

Modeling Analysis and Experimental Study of a Temperature-difference Type Heat Flux Meter

STUDY ON LOCATION OF HOT SPOT AT TUBE WALL FOR FIRED CYLINDRICAL FURNACE COMBUSTION

A THEORETICAL MODEL OF WALL-TO-SUSPENSION HEAT TRANSFER FOR SQUARE-SHAPED CYCLONE SEPARATOR

NONLINEAR MATHEMATICAL MODEL FOR FLOW RATE DISTRIBUTION IN THE PARALLAR TUBES OF BOILER SUPERHEATER/REHEATER AND THE CALCULATION METHOD OF TUBE SURFACE TEMPERATURE

Analysis of the Temperature Field of Tube Wall and Flowing Wet Steam in Heated Tube

Influence of Deposition and Fouling on Wall Temperature Distribution in Convective Path

Flow Heat Transfer and NO_x Emission Characteristic of W-shaped Radiant Tubes with Flue Gas Circulation