Abstract:The accurate prediction of heat transfer behavior in packed bed is of great importance to the design and operation of this kind of facility. In this paper, heat transfer between packed bed and adjacent wall in heat recovery processing is investigated theoretically and experimentally. A bed-to-wall heat transfer model is presented with consideration of two essential components including particle-to-wall contact heat transfer and heat conduction through the thermal penetration layer. Details of model parameter determination are provided. Through comprehensive sensitivity analysis of those parameters, it is shown that particle temperature, particle residence time and particle diameter are critical parameters to heat transfer coefficient. Besides, surface roughness, solid thermal conductivity and environmental gas species are all influencing factors of the overall heat transfer coefficient. In particular, a dimensionless particle residence time is introduced to characterize the combining effect of residence time, effective thermal conductivity and wall contact heat transfer. Meanwhile, a revised simplified formula for calculating particle contact heat transfer coefficient is correlated as well, which provides better prediction than the one widely adopted in previous studies. Furthermore, experimental heat transfer test on an industrial packed bed char cooler is performed for validating the model predicting capability in heat recovery process. The systematical test on a bench scale packed bed heat exchanger has also been carried out. Parametric analysis of the experimental data is consistent with the conclusions drawn from the model analysis section. The model provides good predicting accuracy on the overall heat transfer coefficient from the bench scale facility as well as data from the field test by correlating 95% of the measured data within ±20%. The implementation of the proposed model shows good prediction of heat transfer coefficient in packed bed for heat recovery purpose. It is recommended that the model can be applied in industrial design.

A THEORETICAL MODEL OF WALL-TO-SUSPENSION HEAT TRANSFER FOR SQUARE-SHAPED CYCLONE SEPARATOR

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

Numerical Simulating the Gas-solid Flow in Square Cyclone With a Curved Inlet

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Instantaneous Separation Model of a Square Cyclone

RADIATION HEAT TRANSFER MODEL OF A CIRCULATING FLUIDIZED BED

Development of a new semi-mechanistic wall boiling heat transfer model for CFD methodology focusing on macroscopic parameters

Suspended Surface Heat Transfer in a Large Circulating Fluidized Bed Boiler Furnace

Numerical simulation of the particle-wall collision strength and swirling effect on the performance of the axial flow cyclone separator

Experimental Investigation and Model Validation of the Heat Flux Profile in a 300 MW CFB Boiler

A wall heat transfer model for subcooled boiling flow

Theoretical and experimental analysis of bed-to-wall heat transfer in heat recovery processing

Heat transfer characteristic of water wall and partition wall in a 600 MW CFB boiler

Experimental study on the gas-solid two-phase flow in a square cyclone separator with downward gas exit by particle dynamic analyzer

Heat Transfer Coefficient Calculation of a Circulating Fluidized Bed Boiler for Different Operating Modes

Instantaneous separation model of a square cyclone1Supported by the National Natural Science Foundation.1

The Numerical Simulation of Calculating Grade Efficiency for Cyclone Separator of CFB boiler

Membrane wall heat transfer in a circulating fluidized bed and its modeling

Heat-Transfer Model of the Rotary Ash Cooler Used in Circulating Fluidized-Bed Boilers

Hot test of material balance in a 75 t/h CFB boiler with water cooled square separator

Performance assessment of turbulence models in CFX for predicting heat transfer of supercritical water