Abstract:The transition section between bottom dense zone and top dilute zone is important for fast gas-solids catalytic reactions,such as methanol to olefins(MTO).Solids concentration and fluctuation parameters in the transition section of a fluidized bed with 95 mm i.d.were measured by using reflective optical fiber probe(PV6D).The influences of superficial gas velocity and static bed height were investigated.An Eulerian-Eulerian two-fluid model that incorporated kinetic theory of granular flow and modified three-zone drag law was used to predict the flow structure in the turbulent fluidized bed.The axial and radial distributions of solids concentration were simulated by means of computational fluid dynamics(CFD).The experiments showed two axial profiles of solids distribution in the transition section:exponential and S-shaped.The maximum gradients of both axial and radial solids concentration profiles were located in the transition section,which meant that solids distribution in the transition section was much more non-uniform than that in the dilute and dense sections.The change of gas velocity and static bed height would cause a shift between exponential and S-shaped profiles,and significantly affect solids concentration in the dense region near the wall and at the bottom.Probability density distribution of local solids concentration revealed that when static bed height was small,the location of maximum voidage would gradually move from core region to annular region with increasing gas velocity,resulting in a bimodal distribution of voidage.A modified three-zone drag model was proposed by taking the effect of particle clustering into account for CFD simulation.The simulated solids concentration distribution agreed well with experimental data in the transition section except for the distributor zone.

Membrane wall heat transfer in a circulating fluidized bed and its modeling

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Heat transfer in circulating fluidized bed and its modeling

Modeling Agglomeration Behavior in High Temperature Gas–Solid Fluidized Beds Via Monte Carlo Method

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Heat Transfer of Batch Simulating Continuous Fluidized Bed with Wet Particles

RADIATION HEAT TRANSFER MODEL OF A CIRCULATING FLUIDIZED BED

Model of heat transfer in circulating fluidized bed combustor

Particle-Fluid Heat Transfer In A Circulating Fluidized Bed

Finite element analysis of the heat transfer coefficient of a membrane wall

Heat Transfer in a Pressurized Circulating Fluidized Bed

Analysis Of The Heat Transfer Mechanism In High-Temperature Circulating Fluidized Beds By A Numerical Model

Modeling of Wall-to-Bed Heat Transfer in a Supercritical Water Fluidized Bed by the Packet Approach

3D Modelling. of Radiative Heat Transfer in Circulating Fluidized Bed Combustors: Influence of the Particulate Composition

Heat Transfer Characteristics of Horizontal Tubes in the Dilute Phase of the Pressurized Fluidized Bed

On the treatment of bed-to-wall heat transfer in CFD-DEM simulations of gas-fluidized beds

Solid particle convection models in the dense phase of fluidized bed

Computational Fluid Dynamics Simulations of Interphase Heat Transfer in a Bubbling Fluidized Bed

Heat Transfer Coefficient Calculation of a Circulating Fluidized Bed Boiler for Different Operating Modes