Abstract:The Ti45Zr35Cu5Ni15 bulk metallic glass with a small amount of nanocrystalline was prepared by copper mould injection casting. The dynamic compression properties of the alloy was investigated with the split Hopkinson pressure bar (SHPB) under high strain rates at room temperature (25 degrees C), -80 degrees C and liquid nitrogen temperature (-196 degrees C). The morphology characteristics of the compression fracture were observed by field emission scanning electron microscope (SEM) with energy spectrum. Comparative analysis shows that the material exhibits maximum dynamic compressive strength and plastic deformation at -80 degrees C, and the maximum compressive strength reaches 2378 MPa when the plastic strain reaches 12%, which exhibits excellent mechanical strength and toughness. Furthermore, uncommon profuse wrinkles are also found on the fracture surface. The mechanical properties of the materials are similar at room temperature and liquid nitrogen temperature. The maximum compressive strength is around 1600 MPa while the plastic strain reaches about 8%, and the river pattern on the fracture surface of the material could also be observed. In addition, the material shows strain softening at room temperature and strain rate strengthening to a certain extent at low temperature.

Plastic deformability and precipitation of nanocrystallites during compression for a Cu–Zr–Ti–Sn bulk metallic glass

Crystallization-aided extraordinary plastic deformation in nanolayered crystalline Cu/amorphous Cu-Zr micropillars

A Bulk Glassy Cu–Zr–Ti–Sn Alloy with Superior Plasticity

A Bulk Glassy Cu&ndash;Zr&ndash;Ti&ndash;Sn Alloy with Superior Plasticity

Ultrasonic excitation induced nanocrystallization and toughening of Zr<sub>46.75</sub>Cu<sub>46.75</sub>Al<sub>6.5</sub> bulk metallic glass

Superplastic deformation behavior of Zr41.25Ti13.75Ni10Cu12.5Be22.5 bulk metallic glass in the supercooled liquid region

Enhanced Plasticity in a Zr-based Bulk Metallic Glass Containing Nanocrystalline Precipitates

Formation of Ti–Zr–Cu–Ni–Sn–Si Bulk Metallic Glasses with Good Plasticity

Homogeneous plastic deformation in a Cu-based bulk amorphous alloy

A Plastic Zr–Cu–Ag–Al Bulk Metallic Glass

Homogeneous flow and superplastic forming process of Ti-Zr-Cu-Pd-Sn bulk metallic glass in supercooled liquid region

Superplastic Formability of a Zr–Ti–Ni–Cu–Be Bulk Metallic Glass

Enhanced Ductility in a Zr65Cu15Al10Ni10 Bulk Metallic Glass by Nanocrystallization During Compression

High Temperature Deformation Behaviors of Ti40Zr25Ni3Cu12Be20 Bulk Metallic Glass

Dynamic Compression Properties of Ti<sub>45</sub>Zr<sub>35</sub>Cu<sub>5</sub>Ni<sub>15</sub> Bulk Metallic Glass

Unusual Compressive Plasticity of a Centimeter-Diameter Zr-based Bulk Metallic Glass with High Zr Content

Deformation and Crystallization of a Zr41.2Ti13.8Cu12.5Ni10Be22.5 Bulk Metallic Glass in the Supercooled Liquid Region

In‐Situ Precipitated Nanocrystal Beneficial to Enhanced Plasticity of Cu‐Zr Based Bulk Metallic Glasses

Structural Origins for the High Plasticity of a Zr–Cu–Ni–Al Bulk Metallic Glass

Size dependent plasticity of a Zr-based bulk metallic glass during room temperature compression

An in Situ Neutron Diffraction Study of Plastic Deformation in a Cu46.5Zr46.5Al7 Bulk Metallic Glass Composite

Plastic deformability and precipitation of nanocrystallites during compression for a Cu–Zr–Ti–Sn bulk metallic glass

Crystallization-aided extraordinary plastic deformation in nanolayered crystalline Cu/amorphous Cu-Zr micropillars

A Bulk Glassy Cu–Zr–Ti–Sn Alloy with Superior Plasticity

A Bulk Glassy Cu&amp;ndash;Zr&amp;ndash;Ti&amp;ndash;Sn Alloy with Superior Plasticity

Ultrasonic excitation induced nanocrystallization and toughening of Zr<sub>46.75</sub>Cu<sub>46.75</sub>Al<sub>6.5</sub> bulk metallic glass

Superplastic deformation behavior of Zr41.25Ti13.75Ni10Cu12.5Be22.5 bulk metallic glass in the supercooled liquid region

Enhanced Plasticity in a Zr-based Bulk Metallic Glass Containing Nanocrystalline Precipitates

Formation of Ti–Zr–Cu–Ni–Sn–Si Bulk Metallic Glasses with Good Plasticity

Homogeneous plastic deformation in a Cu-based bulk amorphous alloy

A Plastic Zr–Cu–Ag–Al Bulk Metallic Glass

Homogeneous flow and superplastic forming process of Ti-Zr-Cu-Pd-Sn bulk metallic glass in supercooled liquid region

Superplastic Formability of a Zr–Ti–Ni–Cu–Be Bulk Metallic Glass

Enhanced Ductility in a Zr65Cu15Al10Ni10 Bulk Metallic Glass by Nanocrystallization During Compression

High Temperature Deformation Behaviors of Ti40Zr25Ni3Cu12Be20 Bulk Metallic Glass

Dynamic Compression Properties of Ti<sub>45</sub>Zr<sub>35</sub>Cu<sub>5</sub>Ni<sub>15</sub> Bulk Metallic Glass

Unusual Compressive Plasticity of a Centimeter-Diameter Zr-based Bulk Metallic Glass with High Zr Content

Deformation and Crystallization of a Zr41.2Ti13.8Cu12.5Ni10Be22.5 Bulk Metallic Glass in the Supercooled Liquid Region

In‐Situ Precipitated Nanocrystal Beneficial to Enhanced Plasticity of Cu‐Zr Based Bulk Metallic Glasses

Structural Origins for the High Plasticity of a Zr–Cu–Ni–Al Bulk Metallic Glass

Size dependent plasticity of a Zr-based bulk metallic glass during room temperature compression

An in Situ Neutron Diffraction Study of Plastic Deformation in a Cu46.5Zr46.5Al7 Bulk Metallic Glass Composite

A Bulk Glassy Cu–Zr–Ti–Sn Alloy with Superior Plasticity