Abstract:Obtaining intergranular and transgranular fractures through grain boundary engineering has been considered an efficient technique that improves the effective fracture toughness of polycrystalline aggregates. In this paper, the idealized hexagonal microstructure, random microstructures, and microstructures of grains with large aspect ratios are analyzed through a semi-analytical approach and the cohesive finite element method. The results indicate that when the aspect ratio of grains is not too large, the crack paths consisting of intergranular and transgranular fractures are approximately Mode I fracture morphologies among these microstructures. As the ratio of toughness between grain boundaries and grains varies, the effective fracture toughness of the microstructure can be increased more than the grain boundary fracture toughness but cannot exceed the inner grain fracture toughness. In contrast, the microstructure of grains with a large aspect ratio leads to deflected crack paths that are unexpectedly obtained, which implies that the approximate Mode-I intergranular fracture along transverse direction is almost impossible. The results demonstrate that the projected energy dissipation rate along the direction perpendicular to the loading axis can be significantly improved beyond the inner grain fracture toughness by enlarging the aspect ratio of the grains. Nevertheless, the mixed-mode effective fracture toughness is still limited to the grain fracture toughness. Corresponding experiments are also carried out to qualitatively verify the numerical results. The underlying mechanism for this deflection of fracture path is due to the strong anisotropy of fracture toughness. The higher the grain aspect ratio, the greater the anisotropy of the macroscopic effective fracture toughness. The energy favored fracture path is determined by the largest ratio between the driving force and the toughness of fracture over all directions. Therefore, cracks cannot propagate in the direction of the maximum fracture toughness when the aspect ratio of the grain is sufficiently large. The fracture diagrams that vary with the aspect ratio of grain and the ratio of fracture toughness between the grain and grain boundary are provided. The results can provide valuable guidance for designing microstructures and improving fracture toughness in materials.

Toughness Increment by Crack Growth in Toughened Structural Materials

Toughening materials: enhancing resistance to fracture

Pinning cracks by microstructure design in brittle materials

Enhancing toughness through geometric control of the process zone

An extreme toughening mechanism for soft materials

Anomalous Scaling Law of Strength and Toughness in Polymers with Strong Interfacial Secondary Bonds

Predicting fracture energies and crack-tip fields of soft tough materials

A computational approach to ductile crack growth under large scale yielding conditions

Intrinsic-to-extrinsic transition in fracture toughness through structural design: A lesson from nature

Complexity of crack front geometry enhances toughness of brittle solids

Tough and Fatigue-Resistant Polymer Networks by Crack Tip Softening

Concurrent factors determine toughening in the hydraulic fracture of poroelastic composites

Crack-tip plasticity and intrinsic toughening in nano-sized brittle amorphous carbon

Theoretical modeling of toughening mechanisms in the CrMnFeCoNi high-entropy alloy at room temperature

On the Fracture Toughness of Advanced Materials

Toughening by nano-scaled twin boundaries in nanocrystals

Toughening by crack deflection in the homogenization of brittle composites with soft inclusions

Elastomer Toughened Plastics and Its Affecting Factors

New Insight into Toughness Enhancement in a Lath Martensitic Steel

Could Effective Fracture Toughness of Polycrystalline Aggregates Exceed Inner Grain Fracture Toughness by Adjusting Toughness of Grain Boundary?

Mechanical Behavior and Crack Width Control of Hybrid Fiber Reinforced Ductile Cementitious Composites