Abstract:A three-dimensional multi-cell model based on a prototypical, planar solid oxide fuel cell (pSOFC) stack design using compliant mica-based seal gaskets was constructed in this study to perform comprehensive thermal stress analyses by using a commercial finite element analysis (FEA) code. Effects of the applied assembly load on the thermal stress distribution in the given integrated pSOFC stack with such a compressive sealing design were characterized. A comparison was made with a previous study for a similar comprehensive multi-cell pSOFC stack model but using only a rigid type of glass–ceramic sealant instead. Simulation results indicate that stress distributions in the components such as positive electrode-electrolyte-negative electrode (PEN) plate, PEN-supporting window frame, nickel mesh, and interconnect were mainly governed by the thermal expansion mismatch rather than by the applied compressive load. An applied compressive load of 0.6MPa could eliminate the bending deformation in the PEN-frame assembly plate leading to a well joined structure. For a greater applied load, the critical stresses in the glass–ceramic and mica sealants were increased to a potential failure level. In this regard, a 0.6MPa compressive load was considered an optimal assembly load. Changing the seal between the connecting metallic PEN-supporting frame and interconnect from a rigid type of glass–ceramic sealant to a compressive type of mica gasket would significantly influence the thermal stress distribution in the PEN plate. The critical stress in the PEN was favorably decreased at room temperature but considerably increased at operating temperature due to such a change in sealing design. Such differences in the stress distribution could be ascribed to the differences in the constrained conditions at the interfaces of adjacent components under various sealing designs.

Al_2O_3-based Compressive Seals for Planar Intermediate Temperature Solid Oxide Fuel Cells

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Study on expansion characteristics of Al–Al2O3 composite seals for intermediate‐temperature solid oxide fuel cell

Sealing of Planar Solid Oxide Fuel Cell

The Development of Sealant for Planar SOFC

Characteristics Of Bao-Al2o3-B2o3 Glass Sealants For Low Temperature Solid Oxide Fuel Cells

Measurement Of The Gas Sealing In The Planer Solid Oxide Fuel Cell

Research of Sealing Materials in SOFC

Deformation behavior and leakage tests of alternate sealing materials for SOFC stacks

Study of Sealing Materials and Sealing Experiments in SOFC

Sealing Technology for Solid Oxide Fuel Cells (SOFC)

The effect of CaO/MgO content on properties of barium aluminosilicate sealants for solid oxide fuel cells

Y2O3–BaO–SiO2–B2O3–Al2O3 Glass Sealant for Solid Oxide Fuel Cells

Sealing Properties of SOFC Stack Sealed by Mica and Glass Composite

On the Sealing Materials for SOFC

Investigation of the Glass-Ceramic Sealants in SOFC Stacks

Calcium–Borosilicate Glass-Ceramics as a Sealant for Solid Oxide Fuel Cells

Structure and High Temperature Physical Properties of Glass Seal Materials in Solid Oxide Electrolysis Cell

Thermal stress analysis of planar solid oxide fuel cell stacks: Effects of sealing design

Improvement of thermal cycle stability of YSZ-glass composite seals for intermediate temperature solid oxide fuel cell

Sealing Materials and Sealing Technologies of SOFC