Abstract:Yunnan Guangdong 800kV ultra high voltage and Guizhou Guangdong Ⅱ 500kV DC transmission projects are under construction in Guangdong province. Each HVDC project should have a grounding electrode. But there are already three HVDC grounding electrodes built in Guangdong province. So it is difficult to find proper locations to build two grounding electrode for both projects. Several studies already done show that common grounding electrode would not influence the operation performances of two HVDC transmission projects. In order to reduce both construction area and cost, Yunnan Guangdong 800kV ultra high voltage and Guizhou Guangdong Ⅱ 500kV DC transmission projects will share a common grounding electrode in Guangdong province.The influence of HVDC transmission projects on the environment nearby is smaller by sharing a common grounding electrode than that by building two grounding electrodes separately for each project. Parameters and methods required to design a common grounding electrode for two HVDC transmission projects are different with building a grounding electrode for a single project. Yunnan Guangdong ultra high voltage DC transmission project and Guizhou Guangdong Ⅱ DC transmission project will share a common grounding electrode in Guangdong side in order to reduce both construction area and cost. Common grounding electrode would not influence the performances of two HVDC transmission systems but different parameters are required to build it. According to the system conditions and personal safety requirements, the paper provides several parameters for the electrode design. With the parameters a method coupling moment method with boundary element method is used in the paper to design the common grounding electrode in two locations Daluozhou and Liwu where are possible to build a common grounding electrode. Analysis results of common grounding electrode can satisfy the system requirements and national safety standards for grounding electrodes.

Analysis on the Common Grounding Electrode Mode for UHVDC and HVDC Power Transmission Systems

Influence of Common Grounding Electrode on Yunnan-Guangdong DC Transmission Project and Guizhou-Guangdong Ⅱ DC Transmission Project

Common Grounding Electrode Design for Yunnan-Guangdong and Guizhou-Guangdong Ⅱ DC Transmission Project

Analysis on Common Ground Electrode Technology

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Study on Four HVDC Systems Sharing a Common Ground Electrode

Performance of Different Grounding Systems of 500 Kv XLPE Long Submarine Cables Based on Improved Multiconductor Analysis Method

Study of the Influence of UHVDC Systems Shared Grounding Electrode on the Environment

Analysis of HVDC Linear Ground Electrode System

Common Grounding Electrode Schemes for Multi-terminal MMC-based HVDC

UHVDC Common Ground Electrode Thermal Parameters Analysis

Simulation and analysis of induced voltage and induced current on overhead ground wire of Jindongnan-Nanyang-Jingmen 1000kV UHV AC transmission line

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

Grounding Methods of Multi-Terminal VSC-HVDC System Based on Modular Multi-level Converter

Research of neutral grounding modes for 20kV distribution network

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

Simulation and Analysis of Induced Voltage and Current on Overhead Ground Wire of Huainan～Wannan～Zhebei～Huxi 1000kv UHV AC Double-Circuit Transmission Line

Research of Neutral Grounding Modes for 20 Kv Distribution Network

Protection Characteristics of HVDC Common Grounding Electrode Lines

Grounding System Design of 1000 kV Ultra-high Voltage Substation

Comparison of Insulation Coordination Between ±800kv and ±1100kv UHVDC Systems