Abstract:The high chromium cast irons (HCCIs) with rare earth (RE) nanoparticles or inoculants were fabricated in the casting process. The phase compositions and microstructure were analyzed by X-ray diffraction (XRD) and optical microscopy (OM), respectively. The hardness and impact toughness were tested by Rockwel-hardmeter and impacting test enginery. And then, the morphology of fracture was researched by scanning electron microscopy (SEM). The results demonstrated that the phase compositions of HCCIs with addition of RE nanoparticles or inoculants which were M7C3 carbides + alpha-Fe did not change obviously. However, the prime M7C3 carbides morphology had great changes with the increase of RE nanoparticles, which changed from long lath to granular or island shape. When the content of RE nanoparticles was 0.4 wt.%, the microstructure of high chromium cast iron was refined greatly. The microstructure of carbides was coarser when the addition of RE nanoparticles was higher than 0.4 wt.%. The hardness and impact toughness of HCCIs were improved by addition of RE nanoparticles or inoculants. The impact toughness of HCCIs was increased 36.4% with RE nanoparticles of 0.4 wt.%, but the hardness changed slightly. In addition, the adding of RE nanoparticles or inoculants could reduce the degree of the brittle fracture. Fracture never seemed regular, instead, containing lots of laminates and dimples with the increase of the RE nanoparticles. The results also indicated that the optimal addition amount of the RE nanoparticles was 0.4%, under this composition, the microstructure and mechanical property achieved the best cooperation. In addition, through the study of erosion wear rate, when adding 0.4% RE nanoparticles into the HCCIs, the erosion wear rate got the minimum 0.32x10(-3) g/mm(2), which could increase 51.5% compared with that without any RE nanoparticles.

Effects of Rare Earth Alloys on Structures and Properties of Grey Cast Iron

Examining the role of rare earth elements on grey iron's microstructural and mechanical properties

Effect of Rare Earth Ce on Structure and Properties in 7CrSiMnMoV Die Steel Castings

Effects of Rare Earth Additions on Compound Structure and As-Annealed Properties of Cu-12%Ag

Effects of RE–Al Additions and Austenitising Time on Structural Variations of Medium Carbon Fe–B Cast Alloy

Effects of Rare Earth Addition on Microstructure and Mechanical Properties of a Fe–15Mn–1.5Al–0.6C TWIP Steel

Effects of Rare Earth on the Heat Resistance of Ni-Mo Cast iron in Permanent Mould

Effect of rare earth-al additions on the structural variations of medium carbon Fe-B cast alloy

Effects of Rare Earth Elements on Microstructure and Corrosion Resistance of Low Alloy Steel Based on Ultra-Thin Cast Strip Process

Influence of Rare Earth Nanoparticles and Inoculants on Performance and Microstructure of High Chromium Cast Iron

Effects of rare earth elements on annealing characteristics of Cu–6wt.% Fe composites

Effects of Ce-rich RE on Microstructure and Mechanical Properties of As-Cast Mg-8Li-3Al-2Zn-0.5Nd Alloy with Duplex Structure

Influence of Rare Earth Addition on Microstructure and Properties of the High Strength Cast Steel

The Effect of the Substitution of Silicon by Aluminum on the Properties of Lamellar Graphite Iron

Effect of RE on the structure and properties of B319 aluminium alloy

Effects of Rare Earth Additions on Microstructure and Properties of Cu-6%Fe Filamentary Composites

Segregation of Rare Earth During Isothermal Transformation in Low Carbon Steels

Effect of alloying elements W, Ti, Sn on microstructure and mechanical properties of gray iron 220

The Effect of Rare Earth Metals Alloying on the Internal Quality of Industrially Produced Heavy Steel Forgings

Effect of Re Addition on the Microstructure and Mechanical Properties of AlCoCrFeNi2.1 Eutectic High-Entropy Alloy

Microstructure and properties of typical equiatomic CrMnFeCoNi high entropy alloy doped with different rare earth elements