Abstract:Based on detailed three-dimensional finite element (3D FE) analyses, elastic notch-root fields in plates with different thicknesses and notch configurations subjected to uniaxial tension have been investigated. By comparing with the planar notch-root fields and crack-tip fields, the following characteristics of the 3D stress–strain fields near the notch front are revealed: (1) The plate thickness and notch configuration have obvious effects on the stress concentration factor (SCF) Kt, which is higher in finite thickness plates than in plane stress and plane strain cases. (2) The variation of the opening stress normalized by its value at the notch root with a distance x from the root normalized by the root radius ρ is insensitive to the notch configuration and the plate thickness and coincides well with the two-dimensional (2D) planar solution when x/ρ<0.75. (3) Strong 3D effects exist within a radius of about three-eighth the plate thickness from the notch root. Further away from the root, the through-thickness variation of field quantities decreases and, at the radial distance of approximately 1.25 times the plate thickness, all of the through-thickness changes disappear completely. At least for notches with opening angles less than 90°, these “2D–3D” transition distances and the variations of the out-of-plane constraint normalized by its value at the notch root with a distance x from the root normalized by the plate thickness B are essentially independent of the notch configuration and plate thickness. (4) In the 3D-effect zone, the gradient of the out-of-plane strain εzz in the thickness direction is significant near the free surface in thick plates. On the free surface, εzz can be 3.5 times as high as the value on the mid-plane. It is also found that the in-plane stress ratio in an arbitrary thickness plate coincides very well with the 2D solutions within a distance of about three-tenth of the root radius from the notch root.

Elastic and elastic–plastic fields on circular rings containing a V-notch under inclined loads

A unified expression of elastic-plastic notch stress-strain calculation in bodies subjected to multiaxial cyclic loading

Effects Of Notch Geometry On The Local Cleavage Fracture Stress Sigma(F)

Elastic-plastic Torque Analysis of Notched Cross-Section Cylinder

A Local Approach for Fracture Analysis of V- Notch Specimens under Mode-I Loading

Elasto-plastic fracture criterion for structural components with sharp V-shaped notches

Modeling of fatigue crack growth from a notch

Elastic-Plastic Torque Analysis of Notched Cross-Section Bars Using the Finite Difference Method

Analysis of Elastoplastic Sharp Notches

Sub-region Mixed Finite Element Analysis of V-notched Plates

Numerical-Analysis of Strain-Rate Field below Notch Root of Charpy V-Notch Test Specimen under Impact Loading Condition

Influencing Factors on Local Stress-Strain Responses of Notched Specimen

A concise review about fracture assessments of brittle solids with V-notches

Effect of elliptical notches on mechanical response and progressive damage of FMLs under tensile loading

Complete elastic–plastic stress asymptotic solutions near general plane V-notch tips

Effects of Loading Rate on the Local Cleavage Fracture Stress Σf in Notched Specimens

Failure Criteria for Brittle Notched Specimens

Three-dimensional elastic stress fields near notches in finite thickness plates

Effects of geometry of notched specimens on the local cleavage fracture stress σf of C–Mn steel

An Improved Semi-Analytical Solution for Stress at Round-Tip Notches

Effects of Notch Opening Angle on Local Cleavage Fracture Stress