Abstract:The lack of test data on the fatigue crack growth behaviour of Q420C steel affects its application in the field of wind power engineering. To fill this gap, this paper carried out an experimental study and theoretical analysis of the fatigue crack propagation behaviour of Q420C steel under constant amplitude. Six compact tension specimens were separately tested under six loading conditions comprising two maximum loads (Fmax = 8 kN or 10 kN) and three load ratios (R = 0.1, 0.3, or 0.5). The test results show that for the two crack growth rate calculation methods given by the ASTM E647–15, the secant method provides large discrete results, while the incremental polynomial method can obtain a relatively smooth rate curve. In addition, for the incremental polynomial method, the normalisation of the number of cycles in the ASTM E647–15 should not be used to achieve acceptable results. The rate curves of Q420C steel show a clear load ratio effect. Quantitative analysis of the effect of load ratios has shown that two-parameter models based on 'unified theory', such as Walker's model, can accurately describe the effect of load ratios. However, the theory of plasticity-induced crack closure cannot account for the effect of load ratios, as the crack opening load Fop is less than the minimum load Fmin for load ratios greater than 0.1. Finally, a comparison is carried out against the predictions by BS7910; results verify the applicability of BS7910 to Q420C steel material and demonstrate the different degrees of conservatism of all recommended design curves in BS7910.

Test System of Low-Cycle Fatigue Crack Growth Rate

Low Cycle Fatigue Crack Growth Rate of Compacted Graphite Cast Iron

Low-Cycle Fatigue Test of Circular Concrete Filled Tubular Columns

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

A Novel Method for Characterizing the Fatigue Crack Propagation of Steel Via the Weak Magnetic Effect

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

Low Cycle Fatigue Behavior of Original Ferritic P92 Steel at High Temperature: Experiments and Simulations

Responses of cracked stiffened plates to low-cycle fatigue loads

Experimental study on fracture resistant design method for steel structural components at low temperature

A miniaturized thin‐plate low cycle fatigue test method at elevated temperature

An innovative way to measure fatigue crack growth without COD gauge

Statistical Analysis Methods of Fatigue Crack Growth Rate

Thermodynamic Investigation with Synergetic Method on Inner Crack Growth Behavior at Very High Cycle Fatigue Regime

Experimental study and theoretical analysis of ECC type I fatigue fracture after subjected to sub-high temperature

Experimental studies on crack propagation and accumulative mean strain of cracked stiffened plates under low-cycle fatigue loads

In-situ investigation of fatigue crack growth behavior of 34CrNi3Mo high-strength steel

Experimental research on the fatigue crack growth behaviour of Q420C

Life prediction and damage analysis of creep-fatigue combined with high-low cycle loading by using a crystal plasticity-based approach

Numerical Simulation and Mechanism Analysis of Thermal Fatigue Crack for Low-Alloy Steel Brake Disc of High-Speed Train

A low cycle fatigue cracking simulation method of non-ordinary state-based peridynamics