Abstract:Both proton exchange membrane fuel cells (PEMFCs) and anion exchange membrane fuel cells (AEMFCs) can work efficiently at low temperature only at a high humidity, while their performance would decay doubly at a low humidity. In this work, we propose an acid-alkaline hybrid cathode approach to optimize the water management and achieve the operation of PEMFC at a low humidity, where the patterned acid-alkaline catalyst layer (CL) is used in cathode. The results show that the introduction of a patterned alkaline CL can significantly improve the performance of fuel cells at the low humidity. When the alkaline CL pattern is located in the middle of the cathode with 25% ratio, the peak power density (PPD) of resulting fuel cell reaches 1.02 W cm −2 at a 10% relative humidity, which is 31.72% higher than the PPD of the one without the alkaline CL. This improvement is attributed to the optimal water management because the water yielded by acidic CL can fast participate in the reactions in alkaline CL in the cathode. The distribution of relaxation time and computational fluid dynamics simulation further reveal that not only orientation of alkaline CL, but also the location of alkaline CL shows the key influence on the design of self-humidifying MEA. In short, this work proposes a new type of MEA with self-humidifying property to achieve the operation of MEA in a low humidity, which would greatly accelerate the development and application of fuel cells.

Membrane Electrode Assembly with Pt/SiO2/C Anode Catalyst for Proton Exchange Membrane Fuel Cell Operation under Low Humidity Conditions

High-performance Membrane Electrode Assembly with Multi-Functional Pt/SnO2–SiO2/C Catalyst for Proton Exchange Membrane Fuel Cell Operated under Low-Humidity Conditions

Self-humidification of a PEM fuel cell using a novel Pt/SiO2/C anode catalyst

Effect of catalyst layer with zeolite on the performance of a proton exchange membrane fuel cell operated under low-humidity conditions

Designing Membrane Electrode Assembly for Weakly Humidity-Dependent Proton Exchange Membrane Fuel Cells

Designing self-humidifying proton exchange membrane fuel cells by using patterned acid-alkaline hybrid cathodes

Ultrahigh PEMFC performance of a thin-film, dual-electrode assembly with tailored electrode morphology

Proton Exchange Membrane Fuel Cell with Humidifying Zone

A novel preparation for a self-humidifying membrane electrode assembly and performance of its fuel cell

Optimizing proton exchange membrane fuel cell performance at low-humidity via constructing additional anodic water-retaining membrane layer containing sulfonated multi-walled carbon nanotubes

Cultivating titanium dioxide nanoarrays on gas diffusion layer for advancing self-humidifying proton exchange membrane fuel cell

All sprayed fluorine-free membrane electrode assembly for low-platinum and low-humidity proton exchange membrane fuel cells

The Performance of H2/air Self-Humidifying MEA for PEMFC

Patterned Membranes for Proton Exchange Membrane Fuel Cells Working at Low Humidity

Low-platinum dissymmetric membrane electrode assemblies for fuel cells suitable for a variety of external humidification conditions

Preparation of a self-humidifying membrane electrode assembly for fuel cell and its performance analysis

Enhanced MEA Performance for PEMFCs under Low Relative Humidity and Low Oxygen Content Conditions Via Catalyst Functionalization

Development of Cathode Ordered Membrane Electrode Assembly Based on TiO2 Nanowire Array and Ultrasonic Spraying

Dual-functional phosphoric acid-loaded covalent organic framework for PEMFC self-humidification: Optimization on membrane electrode assembly

Performance Enhancement of Air-Breathing Proton Exchange Membrane Fuel Cell Through Utilization of an Effective Self-Humidifying Platinum–carbon Catalyst

The Performance Improvement of Membrane and Electrode Assembly in Open-Cathode Proton Exchange Membrane Fuel Cell