Abstract:Aiming at the problems of traditional catalytic combustion-type gas sensor, such as matching difficulty, poor consistency, high power consumption and poor interchangeability due to manual manufacturing, in this paper a kind of integrated dual bridge catalytic combustion-type alcohol gas sensor is designed and manufactured based on silicon MEMS technology. With ANSYS finite element analysis method the temperature field of the sensor was analyzed, the silicon oxidation-PECVD-oxidation technique was adopted to produce the SiO2-Si3N2-SiO2 microstructure dual bridge carrier with sandwich structure, wet etching method was used to etch the silicon and form a beam structure for reducing the heat consumption. The thin film technology was used to manufacture the platinum film sensitive resistor, and the nano Al2O3-ZrO-ThO. was coated to form the sensor carrier, the Pt-Pd catalyst solution was dipped on the sensitive unit to form the catalytic sensitive bridge arm, the catalyst carrier without coating was used as the reference unit, the chip integration on the micro double bridge was realized, and the sensor was manufactured. The Pt film resistor lines were observed with the electron microscope, the compositions of the carrier sensitive material and compensation material were analyzed with energy spectrum method. The test results show that the sensor can realize the detection of alcohol with the volume fraction of 0-4 500��10-6, has good linear output characteristic; within the temperature range of 20-40��C and humidity range of 30%RH~85%RH, the maximum zero output of the sensor is less than ��2.0% FS, the power consumption is not larger than 0.2 W, both of the response and recovery time are less than 30 s.

A low power catalytic combustion gas sensor based on a suspended membrane microhotplate.

An Ultra Low Power Consumption Methane Gas Detector Based on an Optimized Suspended Membrane Microhotplate

Behaviour of a catalytic combustion methane gas sensor working on pulse mode

Integration of SnO2 Nanoparticles with Micro-hotplatform for Low-power-consumption Gas Sensors

Design and Experimentation with Sandwich Microstructure for Catalytic Combustion-Type Gas Sensors

From Ceramic Tube to Microcantilever: A New Strategy for Low Power, Fast Heating and High Integrated Metal Oxide Semiconductor Gas Sensor

Low Concentration CO Gas Sensor Based on Pulsed-Heating and Wafer-Level Fabricated MEMS Hotplate

Design and realization of catalytic combustion-type gas sensor with sandwich dual bridge microstructure

Towards Low Temperature Operation of Catalytic Gas Sensors: Mesoporous Co3O4-Supported Au-Pd Nanoparticles as Functional Material

A Low Power Cantilever-Based Metal Oxide Semiconductor Gas Sensor

A portable gas sensor based on cataluminescence.

Innovative Thermocatalytic H2 Sensor with Double-Sided Pd Nanocluster Films on an Ultrathin Mica Substrate

Pt Nanostructures Fabricated by Local Hydrothermal Synthesis for Low-Power Catalytic-Combustion Hydrogen Sensors

Highly Sensitive MEMS Sensor Using Bimetallic Pd–Ag Nanoparticles as Catalyst for Acetylene Detection

Monolithic Mid-IR Methane Gas Sensor with Waveguide-Integrated Detector

UV-activated CH 4 gas sensor based on Pd@Ni/ZnO microspheres

High-performance H-2 Sensors with Selectively Hydrophobic Micro-Plate for Self-Aligned Upload of Pd Nanodots Modified Mesoporous In2O3 Sensing-Material

A Millisecond Response And Microwatt Power-Consumption Gas Sensor: Realization Based On Cross-Stacked Individual Pt-Coated Wo3 Nanorods

Design and Simulation of an Ultra-Low-Power Hydrogen Sulfide Gas Sensor with a Cantilever Structure

MEMS based metal oxide semiconductor carbon dioxide gas sensor

A Low Power Bridge-Type Gas Sensor with Enhanced Sensitivity to Ethanol by Sandwiched ZnO/Au/ZnO Film Sputtered in O₂ Atmosphere