Abstract:Precise control of the crystal phase of TiO2 by sputtering at room temperature is particularly important for practical applications. In this paper, nanocrystalline TiO2 films were deposited on glass and silicon substrates using DC reactive magnetron sputtering without external heating. The phase composition and preferred orientation of the TiO2 films could be controlled by adjusting the negative bias voltages. It was found that TiO2 films deposited at free negative bias voltage or ground exhibited an anatase single phase with a strong (101) preferred orientation, while the preferred orientation transformed into (211) when the negative bias voltage reached −50V. A further increase in the negative bias voltage induced the formation of an additional rutile phase, thus generating a mixed phase of anatase and rutile. A pure rutile phase was obtained at high negative bias voltage (≥−100V). The rutile phase with (101) preferred orientation could also be obtained by increasing the bias voltages above −125V. In addition, the TiO2 films of different phases performed different photocatalytic activities. The anatase TiO2 films showed higher photocatalytic activity than rutile phase films. Particularly, anatase TiO2 films with (211) preferred orientation showed a significant photocatalytic degradation of organic dye (Rhodamine B), the degradation of which reached over 90% after an irradiation time of 2h.

Microstructure of Nanostructured Tio2 Coating Prepared by Atmospheric Plasma Spraying and Its Photocatalytic Properties

Influence of Plasma Spraying Parameter on Microstructure and Photocatalytic Properties of Nanostructured TiO2–Fe3O4 Coating

The Microstructure of Al2O3/TiO2-NiCrBSi Graded Thermal Barrier Coatings Produced by Flame Spraying

Photocatalytic performance and microstructure of thermal-sprayed nanostructured TiO2 coatings

Controllable Hydrothermal Synthesis, Optical and Photocatalytic Properties of TiO2 Nanostructures

Influence of Preparation Method on Morphology and Photocatalysis Activity of Nanostructured TiO2.

Microstructures and Properties of N-Doped TiO_2 Films Grown by Atmospheric Pressure Chemical Vapor Deposition

Investigation of structure and properties of N-doped TiO2 thin films grown by APCVD

Photocatalytic performance of plasma sprayed TiO2-ZnFe2O4 coatings

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

The Crystallization Mechanism of Reactive Plasma Spraying

Photocatalytic Performance of Plasma Sprayed Pt-modified TiO2 Coatings under Visible Light Irradiation

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

Photocatalytic Properties Of Columnar Nanostructured Tio2 Films Fabricated By Sputtering Ti And Subsequent Annealing

D. C. Plasma-Sprayed Coatings of Nanostructured Alumina-Titania-Silica

Effect of annealing treatment on the microstructure and current carrying tribological properties of in-situ formed TiO2−x coating prepared by plasma spraying

Investigation on the Performance of TiN Coatings by Reactive Plasma Spraying Crystallization

Microstructure and properties of Al2O3–ZrO2–TiO2 composite coatings prepared by plasma spraying

On controlling microstructure of suspension plasma sprayed yttria-stabilized zirconia topcoat on β-(Ni,Pt)Al bondcoat

Fabrication of TiO2-SrCO3 Composite Coatings by Suspension Plasma Spraying: Microstructure and Enhanced Visible Light Photocatalytic Performances

Study on microstructure evolution and reaction mechanism of in-flight Ti–Si–C agglomerates during reactive plasma spraying using in situ water quenching