Abstract:In the present paper, cracking sequence of high-strength engineered cementitious composite with the characteristic of low drying shrinkage (LSECC) under tension was experimentally studied by continually photographing during loading. The specific objective is to investigate the development of crack opening of each individual crack occurred during loading. Four Engineered cementations composite mixtures with water to binder ratio of 0.20, 0.25, 0.30, and 0.35 (LSECC-0.20, LSECC-0.25, LSECC-0.30, and LSECC-0.35) were used in the tests. Using the photographers taken during the test, crack width of each crack occurred during loading are determined according to the difference between solid material and crack on gray level. The test results show that cracks in ECC under tensile load are formed according to a temporal sequence. The opening width of each crack grows in a controllable and gradual manner with the increase of tensile strain. At a given strain level, crack width of different crack is not equal and the distribution of crack width is affected by matrix strength of the composite. Maximum crack width and the tensile strain capacity at the moment may be utilized to characterize the tensile performance of the composite that can guarantee both of tensile ductility and long-term durability. As maximum crack width equals 60 μm, at which the permeability of ECC may not be influenced by the cracks, higher strength ECC with water to binder ratio of 0.20 and 0.25 (LSECC-0.20 and LSECC-0.25) shows obvious higher tensile strain capacity and more cracks of narrow opening. By contrast, lower strength ECC with water to binder ratio of 0.30 and 0.35 (LSECC-0.30 and LSECC-0.35) shows relatively lower tensile strain and fewer cracks of narrow crack opening as crack width is limited below 60 μm. With the increase of tensile strain and the maximum crack width, much wider cracks (larger than 60 μm) are formed in lower strength ECC comparing to that of higher strength ECC.

Mechanical Performance of Low Shrinkage Engineered Cementitious Composite in Tension and Compression

Compressive Behavior of Engineered Cementitious Composites under High Strain-Rate Loading

Tensile Properties of Low Shrinkage Engineered Cementitious Composite

Characteristics of High Ductility and Low Shrinkage Engineered Cementitious Composite and Its Applications

Engineered Cementitious Composite with Characteristic of Low Drying Shrinkage

Unveil the Role of Nano-Caco3 in Early Shrinkage and Tensile Properties of Cement Paste: from Experimental Work to Modeling

Mechanical Properties and Carbonation Durability of Engineered Cementitious Composites Reinforced by Polypropylene and Hydrophilic Polyvinyl Alcohol Fibers

Effect of Water to Binder Ratio and Sand to Binder Ratio on Shrinkage and Mechanical Properties of High-strength Engineered Cementitious Composite

Mapping of cracking sequence of polyvinyl alcohol-steel hybrid fiber reinforced high-strength engineered cementitious composite under uniaxial tension

Impact of Polyvinyl Alcohol Fiber on the Full Life-Cycle Shrinkage of Cementitious Composite

Design and Performance of Cost-Effective Green Engineered Cementitious Composites with Low Drying Shrinkage and Self-Healing

Engineered cementitious composites using blended limestone calcined clay and fly ash: Mechanical properties and drying shrinkage modeling

Energy Evolution Characteristics of Engineered Cementitious Composites (ECC) under Tensile and Compressive Loading

Investigation of the Mechanical Properties of Engineered Cementitious Composites with Low Fiber Content and with Crumb Rubber and High Fly Ash Content

Durability Performance Investigation for Engineering Fiber Cementitious Composites (ECC): Review

Effect of PE Fiber Content on Mechanical Behavior of Cementitious Composite

The Apparent Density, Tensile Properties and Drying Shrinkage of Ultra High Toughness Cementitious Composites

Engineered Cementitious Composites Using Chinese Local Ingredients: Material Preparation and Numerical Investigation

Simulation and test of flexural performance of polyvinyl alcohol-steel hybrid fiber reinforced cementitious composite

Multiscale Investigation on the Performance of Engineered Cementitious Composites Incorporating PE Fiber and Limstone Calcined Clay Cement (LC3)

Influence of Zeolite Addition on Mechanical Performance and Shrinkage of High Strength Engineered Cementitious Composites