Abstract:It can provide theoretical support for the optimal design of low-energy walls by measuring the actual thermal conditions inside the walls of passive low-energy buildings and studying the rationality of the wall structure design. Taking the teaching and laboratory building of Shandong Jianzhu University as an example, this paper explores the method of using temperature and humidity sensor to measure the air temperature and humidity inside the wall to represent the solid temperature and humidity of the wall. Based on the measured data and calculation results, the rationality of the structure of the test external wall is analyzed from four aspects: the performance of insulation, the moisture drain performance of wall, the ability of preventing the penetration of the hot and humid air of the inner wall, and the waterproof performance of the outer wall. Results show that the external wall structure of polystyrene board (200 mm thick) for external insulation and thin plastering has good practical operation effect in three aspects of thermal insulation, internal moisture discharge, and external wall waterproof, which basically meets the design requirements of external wall of passive house in Germany. In terms of moisture protection of the inner wall, the inner wall of cement mortar (15 mm thick) may not be able to effectively prevent the infiltration of indoor hot and humid air. Thus, the insulation layer should be added into the external wall. In addition, the moisture inside the wall is obviously affected by the season. The drain performance of moisture inside the wall mainly occurs in the sweltering heat, and the drain direction is from the indoor side to the outdoor side. In the external insulation structure, there are two layers of graphite polystyrene plate (100 mm thick), and the insulation effect of polystyrene plate near the outdoor side is better than that near the indoor side. The combination of anticrack mortar (5 mm thick) and paint cannot completely prevent the infiltration of rainwater, but the infiltration of rainwater in the wall will be quickly discharged in a short time.

Research on the Thermal Insulation Performance of a New Polyurethane Composite Exterior Wall

The research for new material and new technology of exterior walls thermal insulation

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

Numerical Study on Wall Insulation Construction Affecting the Energy Consumption under the Intermittent and Loculose Energy Use

Thermal Performance Analysis for a New External Wall Insulation System

Application of Polyurethane Serial Products to External Thermal Insulation System of Exterior Wall

Technology of external thermal insulation of exterior wall and study on application of polyurethane rigid foam to building energy saving

Application Research on Thermal Insulating System of Foamed Ceramic Thermal Insulating Board and Fire Barrier in Building

Research on the Application of New Building Recycled Insulation Materials for Walls

Study on Thermal Performance in Winter of Building Envelope Walls Insulated with Expanded Polystyrene Board

The Comparative Analysis on the Heat Insulation Performance of Several Building Exterior Walls

Influence of the Permeability of External Thermal Insulation on Concrete Wall Carbonization

STUDY OF BEHAVIOR OF EXTERNAL WALL INSULATION SYSTEM BASED ON WEATHERING TEST

Dynamic performance and energy efficiency of reflective and insulative composite coating on building exterior wall

Application of new nanopolymer materials in intelligent thermal insulation system for building external walls

Thermal Performance Analysis of Prefabricated Exterior Wall Panels of Prefabricated Civil Buildings in Hot Summer and Warm Winter Zones

Study on Thermal Performance Measurement and Construction of Passive Exterior Wall with Low Energy: Teaching and Laboratory Building of Shandong Jianzhu University

Study on heat transfer of light steel-framed composite walls in cold area

Thermal Performance of Double Walls With Polystyrene Bead Insufflation

Thermal Performance of Several Wood-Plastic Composite (WPC) Walls

Experimental study of the thermal performance of a building wall with vacuum insulation panels and extruded polystyrene foams