Abstract:Optimizing the locations of sewage treatment plants has enormous practical significance. In this study, a large-system mathematical model was developed for optimizing the locations of sewage treatment plants within a system and designing the associated pumping station pipe network. Head loss of pipe segments in the pipe network was the coupling constraint, the economic flow rate of pipe segments was determined by the feasible region constraints of decision variables, and the design variables were the sewage treatment plant locations, the design head of the pumping stations, the pipeline economic life, and the pipe diameter of divided pipe segments. The minimum total annual cost of the sewage treatment plant(s) and the pumping station pipe network was the objective function. A large-system quadratic orthogonal test-based selection method was used with a discrete enumeration comparison and selection method to determine pipeline economic life. A dynamic programming method was used to determine the pipe diameter of the divided pipe segments. By comparing the total annual cost of the sewage treatment plants and the associated pumping station pipe network corresponding to different pipeline economic lifetimes, the optimal solution that generates the minimum total annual cost can be identified. The sewage treatment plant and pumping station pipe network in Taizhou, China, was used as an example to compare and analyze optimization results. The new optimization method would have produced much lower annual cost than that of the existing system. This study provides valuable theoretical references for probing the layout design of urban sewage treatment plants corresponding to different pipeline economic lifetimes.

Optimum Selection on Pipe Diameter of Feed Water System for 1000 MW Units

Design and Optimization of the Deaerator Steam Supply in Power Plant

Hydraulic characteristics of exhaust pipe of direct air cooling system in 1000 MW level nuclear power units

Optimal Design Method of Direct Air-cooling System for Thermal Power Plants

Optimized design and schemes comparison of station auxiliary power system for 600 MW level units

Computational analysis on hydrodynamic characteristics and flow instability of an ultra supercritical 1000 MW double-reheat unit boiler

Optimizing the system-wide layout of sewage treatment plants based on enumeration and the orthogonal test

Optimum Selection & Design for Pump System of Taierzhuang Pumping Station in the Eastern Route Project of the South-to-North Water Diversion

MODEL TEST AND NUMERICAL ANALYSIS OF FLOW FIELD IN SCR DENITRIFICATION SYSTEM IN SECOND-PHASE PROJECT OF SANHE POWER PLANT

Modeling and Solution for the Cycle Water System in Power Plant

The Design Optimization Method of Steam Turbine Cold End in Coal-Fired Power Plant

Optimum Design of Main Protection Configuration Scheme for Large Generators

Research On Optimal Operation In Large-Scale Steam Piping System

Hydrodynamic characteristic calculation for a 600 MW unit onceGthrough tower boiler

Discussion on the design of 350 MW-class gas-steam combined cycle units

Optimal Design of Circulating Water System in Pressurized Water Reactor Nuclear Power Plant

Experimental study and 3-D numerical simulation on water flow in Y-type pipe

Selection of Water Transmission Method and Analysis of Pipe Network Zoning in Municipal Water Supply and Drainage Design

Analysis of 1000 MW-Grade Supercritical Boiler Starting System

600MW Supercritical Boiler Feedwater Control System Based on Intermediate Point's Enthalpy Adjust

Optimization Design and Operation of CWS System in Wanfeng Heat Power Plant