Abstract:Considering the inherent advantages of the Light Emitting Diode (LED) in the field of illumination, this work designs an intelligent supplementary lighting system using LED as the light source. Combining microcontroller and electronic circuit theory, the circuit is built with the microcontroller PIC16F873 as the core control chip. The system utilizes an external 220 V AC-20 V DC conversion power supply, hence operating on a 20 V DC power source. The system consists of four hardware parts: the onboard power supply uses TI-produced TPS54331 as the control chip to achieve voltage conversion; the external signals (flashing and burst flashing signals) are isolated from the microcontroller through an optocoupler circuit; the PWM pulses output from the microcontroller’s RC1/CCP2 pins drive the corresponding switching tubes to achieve the flashing function; the flashing synchronization signal is output externally after optocoupler isolation, and its synchronous output with the flashing signal is achieved through an optocoupler after LED conduction; the circuit is established using TI-produced differential bus transceiver SN65LBC184D to convert the external 485 differential signal to the level signal required by the microcontroller. In the experiment, after completing the hardware design, connecting the LED panel, and debugging the test program, it is found that the designed lighting system has a good supplementary lighting effect. According to the PWM output waveform, the flashing effect meets the design expectations. The Hadoop big data computing platform is introduced. Simulation testing reveals that under no backlight conditions, the system achieves an illumination intensity of around 20 klx at a distance of about 10 meters. With backlight conditions, the system maintains an illumination intensity of around 1.5 klx at a distance of about 10 meters. Further calculations are performed to analyze the variation in foot traffic within the test area’s illumination over 24 hours. The total illumination intensity during different time intervals is compiled, confirming that the system can autonomously adjust the illumination intensity of the area based on changes in foot traffic.

Design of Illumination Meter Based on BH1710

Research on illumination measurement system by segmented calibration based on MCU

Indoor Lighting System Based on Intelligent Detecting Technology

Automatic Measurement for Light Distribution Curve of Ultra High Pressure Mercury Lamps

Design of Vehicle Tunnel Illumination Measurement Device Based on STC12C5A60S2 Single-Chip Microcomputer

Design of Intelligent HB LED Illumination System Based on MCU Controller

Automatic Monitoring and Controlling LED Energy Saving Lighting System Based on C8051F020 MCU

Measuring surface light source luminance by using digital imaging device

Design and Research of Photometer with Intellectual Faculties

Design and development of digital light intensity measurement instrument

Intelligent Light Emitting Diode Flashing Supplementary Lighting Control Design and Its Big Data Illumination Analysis

Fast and High-Accuracy Spectral Measurements of LED by Linear CCD Sensor and Software Calibration

Study on a system for LED's photometric and colorimetric measurement based on a multi-channel spectrometer

Embedded Automatic Control System for Temperature, Humidity and Light Intensity in Agricultural Greenhouses

Design of a simple DC digital voltmeter

A Design Of A Measuring And Control System Of Partial Environmental Illuminance

A Design of LED Light Intensity Distribution Measuring Device and Fitting in Matlab

LED Projection Light Brightness Uniformity Detection System Design

Efficient Single-Pixel Batch Measurement Method for Optical Properties of Micro-Sized LED Array

Design of High-Precision Infrared Photoelectric Sensor and Its Adoption in Soft Package Counting Management in Workshop

Experimental Measurement and Analysis: Collimation and Illumination for Conformity Measuring Instrument Design in X-ray Modality