Abstract:Composite ceramics of 0.7BaO center dot 0.3SrO center dot(I-gamma)TiO2 center dot gamma Nb2O5 (BSTN) with coexistence of barium strontium titanate, Ba1-xSrxTiO3 (BST), and strontium barium mobate, SrxBa1-xNb2O6 (SBN) phases were successfully prepared in situ by controlling excess components according to a specially designed formula of 0.7BaO center dot 0.3SrO center dot(1-gamma)TiO2 center dot gamma Nb2O5 and by using a traditional ceramic process. X-ray diffractometry (XRD), scanning electron microscopy (SEM) and energy dispersion spectrometer (EDS) were used to characterize the phase composition, morphology and the micro-area chemical composition of the composite ceramics. The results showed that the SBN tungsten bronze phase appeared and coexisted stably with the BST perovskite phase when the excess content of Nb2O5 was > 6mol%, whereas the BST perovsklite phase formed and coexisted stably with the SBN tungsten bronze phase when the excess content of TiO2 was > 5.3mol%. In the ease of the two phases being equivalent to each other in BSTN composite ceramics, Nb2O5 was hard to be resolved into the perovskite phase, however, a few of TiO2 was easy to be resolved in the tungsten bronze phase. The microstructure of the composite ceramics were consisted of two kinds of grains. The smaller polygonal grains were belonged to the BST phase, and the larger ones to the SBN phase. The coexistence of the two phases inhibited the growth of the BST crystal. The density of microstructure of the composite ceramic was higher than that of both the pure BST and SBN calcined at the same temperature for the same time.

The Effects of Incomplete Combustion on Ba2Ti9O20 Phase Formation in a Citrate Solution Combustion Method

Citrate Solution Combustion Derived Ba2Ti9O20 Ceramics

A Study on CSC-derived Ba 2 Ti 9 O 20 Phase Formation and Its Dielectric Property

The Effect of B2o3-Li2co3 Addition on Sintering Behavior and Dielectric Properties of Ba0.6sr0.4tio3 Ceramics

PREPARATION AND SINTERING PROPERTIES OF BaTi4O9 BY CITRIC ACID GEL METHOD

In situ Preparation of BST(Nb)/SBN(Ti) Composites

Soot Combustion Performance and H2-TPR Study on Ceria-Based Mixed Oxides

Preparation and characterization of TiB2-Al2O3 composite powder by combustion synthesis process

Effects of different Al contents on combustion synthesis of Ti3AlC2 powders in the Ti-Al-C system

Preparation and Characterization of Citrate Sol-Gel Derived Ba(Zr,Ti)O3 Ceramics with Al2O3 Addition

The Effect of Processing Parameters on Low-Temperature Combustion Synthesis Barium Titanate Powders

Low-temperature combustion synthesis of nanometer tetragonal barium titanate powders

Effect of the Fuel Type on the Synthesis of Barium Strontium Titanate by Sol-Gel Combustion Method

Effects of different Ti/C and Al contents on combustion synthesized Ti3AlC2 powders in the Ti-Al-C system

Effect of reactant Ti/B4C ratio on the stoichiometry and mechanical properties of h-BN–Ti(C,N) prepared by combustion synthesis

Phase formation and electrical properties of SBNLT ceramics prepared via combustion technique

Effects of TiAl additions on combustion synthesis of Ti3AlC2 powders

PREPARATION OF TIB2/TIC CERAMIC COMPOSITES BY HIGH-GRAVITY COMBUSTION SYNTHESIS

The Process of TiB 2 −cu Composite Phase and Structure Formation During Combustion Synthesis

Effects of Boron Content on the Microstructure and Properties of BxC-TiB2 (x=4.5, 6.5 or 8.5) Ceramic Composites by the Reactive Spark Plasma Sintering

Self-propagation High-temperature Synthesis of Porous TiB2-TiC Multiphase Ceramics