Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Feasibility Research on Road Response Spectrum Testing of Tracked Vehicle

Design of tractor vibration testing system

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Study on the Virtual Testing Platform of Vehicle Vibration Based on VR

A Research on the Resistance Simulation Method for Multi-axle Vehicle Driving on Complex Road

The Influence of Transient Soft Terrain on Vertical Vibration of Vehicle

Environmental vibration induced by vehicle in complicated field

Vibration Response and Evaluation Method of High-Speed Tracked Vehicles Driving Off-Road

Ride Comfort Simulation of Tracked Vehicles from Stochastic Excitation Based on Road Surface Spectrum

Research on the Online Measurement of Automobile Engine Speed Based on Vibration Analysis

Vehicle parameter identification and road roughness estimation using vehicle responses measured in field tests

Research and Produce of Vibration Test Bed for Caterpillar Vehicles Based on Typical Sinusoidal Road Surface

Study of Ground Vibration from Trains Caused by Track Irregularities

Estimation of Road Roughness Based on Both the Sprung and Unsprung Response of a Moving Vehicle over Ordinary Roads: Modeling, Experiments and Discussions

Research on rapid measurement of medium short wave longitudinal road profiles

The testing and improving of the heavy truck vibration

Comprehensive validation of three-dimensional finite element modelling of wheel-rail high-frequency interaction via the V-Track test rig

An Efficient Real-Time Vehicle Monitoring Method

Dynamic Simulation of Tracked Vehicle Vibration System Based on Three-dimensional Road Surface Spectrum Model

Low-Cost Portable Road Smoothness Testing Method Based on Pseudo-Vibration Velocity Range

A novel method for evaluating asphalt pavement structural performance based on vehicle vibration