Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Research on the Online Measurement of Automobile Engine Speed Based on Vibration Analysis

Design of tractor vibration testing system

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Research of automatic control system for ultralow frequency vibration calibration

The Design of the Virtual Testing System of Vehicle Vibration Based on VR

Study on the Virtual Testing Platform of Vehicle Vibration Based on VR

Virtual Accelerometer Approach to Create Vibration Profile for Automotive Component Shake Test

Measurement And Analysis Of Vibration And Noise Signals Of Rotating Machines By Non-Invasive Method

Noncontact Distance and Amplitude-Independent Vibration Measurement Based on an Extended DACM Algorithm

Research on Speed Measurement Signal Denoising Processing of Laser Doppler Vibrometer

Design and evaluation of a remote measurement system for the online monitoring of rail vibration signals

Optimization of aero-engine condition monitoring by autoregressive model analysis based on wireless communication

Research on the Method and Application for a Vehicle’s Online Diagnosis Based on a Testability Model

Low-Cost Portable Road Smoothness Testing Method Based on Pseudo-Vibration Velocity Range

Development and Validation of a Vibration-Based Virtual Sensor for Real-Time Monitoring NOx Emissions of a Diesel Engine

Research on rapid measurement of medium short wave longitudinal road profiles

Application of Photoelectric Sensor in Vehicle Power Control System

Design and Implementation of Measurement System for Power Dissipation Characteristic of Vibration Damper Based on Virtual Instrument

Exploration of Vibration Signal Measurement Method of Automobile Parts Utilizing FPGA/Photoelectric Sensor

Engine Fault Detection Using Vibration Signal Reconstruction in the Crank-Angle Domain

Design of Front End Processing Module for Engine Vibrating Signal