Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Design of tractor vibration testing system

Study on Vibration Characteristics of the Tractor Seat

Testing System of Characteristics of Electrical Vibration Table

Study on Tractor Vibration Based on Wavelet and Multiple Linear Regression

Development Of Automatic Vibration Calibration System

Research of automatic control system for ultralow frequency vibration calibration

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

The Design of the Virtual Testing System of Vehicle Vibration Based on VR

Progress in Multi-Exciter Vibration Testing Control Technology

Design and Implementation of Vibration Test Control System of Multi-Exciter Synchronization

Study on the Virtual Testing Platform of Vehicle Vibration Based on VR

A Study on the Noise and Vibration Testing System for Automotive Final Drive

Tractor Manufacturing Quality Data Acquisition, Analysis And Utilization

Chaos identification of tractor vibration signals with numerical methods

Study on Test System of Thermal-Vibration Combined Envir Onment under High Linear Acceleration

The design of vibration testing system based on lab VIEW for wind turbine

The testing and improving of the heavy truck vibration

Research on the Online Measurement of Automobile Engine Speed Based on Vibration Analysis

Design and application of gearbox vibration testing system

Establishment of a measuring unit based on Arduino board for recording vibrations on an agricultural tractor during tillage process

Vibration comfort assessment of tractor drivers based on sEMG and vibration signals