Abstract:SiC layer was prepared in an industrial scale spout fluidized bed by chemical vapor deposition. The density of SiC coating was about 3.18 g/cm(3). High temperature oxidation experiments were carried out at different temperatures from 800 to 1600 degrees C. The microstructure and composition were characterized using different methods, including mass change weighing, XRD, EDS and SEM. It was found that the weight gain of SiC coating layer was not obvious below 1200 degrees C, and subsequent mass gain gradually increased with increasing temperature, reaching 10% at 1600 degrees C. High-magnification SEM results show that the oxidation began from the surface and gradually formed punctate distribution of the oxide. Small crystal structure (similar to micron) of the SiC surface was very clear at 1000 degrees C, and this crystal structure disappeared gradually at high temperatures, forming oxides of Si in the SiC surface. There was a stacking fault stress due to the different thermal expansion coefficients and elastic modulus of SiC and Si oxides, leading to the gradual formation of cracks around the punctates. With increasing temperature, the crack further increased the oxidation rate of SiC, and finally the formed Si oxides layer fell off from the particles. It can be seen clearly that the layer was peeling when the temperature was increased to 1400 degrees C. Increasing the temperature to 1600 degrees C, the SiC coating was oxidized completely into a honeycomb structure, with obvious sintering of SiC. XRD analysis shows that there was a growing SiO2 peaks from 1400 degrees C, indicating that surface oxidation was significant. EDS results shows that the oxygen content in the coating surface gradually increased with increasing temperature. Semi-quantitative analysis shows that the surface was close to SiO2 at 1600 degrees C.

The coating process of silica film on TiH2 particles and gas release characteristic

Coating process of silica film on TiH2 particles and hydrogen release characteristics

Effect of SiO2 coating layer morphology on TiH2 gas release characteristic.

The effect of SiO2 and Al2O3 coating on the surface of TiH2 powders on gas release.

Bioactive Titania-Gel Layers Formed by Chemical Treatment of Ti Substrate with a H2O2/HCl Solution.

The Coating Process of Nano-scale Hydrous Silica Film on TiO2 Particles by Chemical Deposition in Aqueous Solution

Film-Coating Process of Hydrated Alumina on TiO<sub>2</sub>Particles

Preparation of TiO2/SiO2 Composite by Chemical Coating Method

Mechanism and structure analysis of TiO 2 surface coated with SiO 2 and Al 2O 3

Surface characteristics of hydrous silica-coated TiO2 particles

Preparation and Releasing Hydrogen Characteristic of Al2O3-Coated TiH2 Particles

Mechanism and Structure Analysis of Tio2 Surface Coated with Sio2 and Al2o3

Oxidation Resistance of SiO2 Bonded Coating Formed on Ti–Al–Zr Alloy

Differences among SiO2, TiO2, and Ti in the anti-foaming mechanism of chemically bonded silicate coatings

Surface Modification Of Nano-Sic Powders By Coating With Heterogeneous Nucleation Process

Vapour phase codeposition of Al and Si to form diffusion coatings on γ-TiAl

The Process Study of SiO2 Coating on α-FeOOH Particles by Surface Hydrolysis Reaction in Fluidized BED Reactor

High Temperature Oxidation Behavior of SiC Coating Materials

Hydro-silica deposition on TiO2 and its effect on pigmentary performance

Synergetic effect of sol–gel silica coating and physical/chemical pre-treatment on the oxidation behavior of Ti-6Al-4V alloy

Reactive sputtering TiO2 films for surface coating of poly(dimethylsiloxane)