Abstract:Solid oxide fuel cells (SOFC) has attracted considerable attention in recent years as a power conversion system, owing to its high-energy conversion efficiency, fuel flexibility and low pollution emissions as well. Recently, the intermediate temperature-solid oxide fuel cell (IT-SOFC), which operates at lower temperatures (600~800 °C) to reduce cost and to improve efficiency, appears to be an alternative choice for the development of SOFC. La0.8Sr0.2Ga0.8Mg0.2O3 (LSGM), with a perovskite structure, presents a high ionic conductivity at intermediate temperatures. However, the common methods to fabricate the LSGM electrolyte (e.g., solid state method) often lose their advantages owing to the depletion of Ga and the interfacial reaction between the LSGM and electrodes. Vacuum cold spray (VCS), based on the impact adhesion of fine particles to build up ceramic film at room temperature, is a new and promising method to fabricate thin (﹤20 mm) and dense (LSGM) electrolyte membrane. In the present study, the LSGM electrolyte layer with a thickness of ~10 mm is prepared by a home-developed VCS system assisted with in-situ particle heating approach (25~400 °C). The output performance of cells assembled with VCS-LSGM is determined at 500~750 °C. Results show that the OCV value is above 1.0 V, suggesting that the VCS-LSGM electrolyte is dense enough for the application to SOFC. Meanwhile, the ionic conductivities of LSGM coatings prepared by different in-situ particle heating temperatures were determined by an electrochemical impedance spectroscopy system. In addition, the microstructure and phase structure of LSGM coatings was characterized by scanning electron microscopy and X-ray diffraction. Based on this study, it is possible to conclude that the VCS is a promising method to prepare the LSGM electrolyte applied in the IT-SOFC.

Characterization of atmospheric plasma-sprayed La0.8Sr0.2Ga0.8Mg0.2O3 electrolyte

Dominant Factors Influencing the Electrochemical Performance of Plasma-Sprayed LSGM Electrolyte

Microstructure and Electrochemical Properties of La0.8Sr0.2Ga0.8Mg0.2O3 Thin Film Deposited by Vacuum Cold Spray for Solid Oxide Fuel Cells

Characterization of the Microstructure and Electrical Conductivity of Plasma-Sprayed La0.5Sr0.5CoO3 Coating

Application of High Velocity Oxygen Fuel Flame (HVOF) Spraying to Fabrication of La0.8Sr0.2Ga0.8Mg0.2O3 Electrolyte for Solid Oxide Fuel Cells

Effect of Spray Parameters on the Electrical Conductivity of Plasma-Sprayed La1−xSrxMnO3 Coating for the Cathode of SOFCs

Performance of La0.8Sr0.2Ga0.8Mg0.2O3-based SOFCs with Atmospheric Plasma Sprayed La-doped CeO2 Buffer Layer

Microstructure and Electrochemical Behavior of La0.8Sr0.2MnO3 Deposited by Solution Precursor Plasma Spraying

Preparation of bulk-like La0.8Sr0.2Ga0.8Mg0.2O3-δ coatings for porous metal-supported solid oxide fuel cells via plasma spraying at increased particle temperatures

Effect of Microstructures on Electrochemical Behavior of La0.8Sr0.2MnO3 Deposited by Suspension Plasma Spraying

La0.8Sr0.2Ga0.8Mg0.2O3 Electrolytes Prepared by Vacuum Cold Spray under Heated Gas for Improved Performance of SOFCs

Atmospheric Plasma-Sprayed La0.8sr0.2ga0.8mg0.2o3 Electrolyte Membranes for Intermediate-Temperature Solid Oxide Fuel Cells

Characterization of YSZ Solid Oxide Fuel Cells Electrolyte Deposited by Atmospheric Plasma Spraying and Low Pressure Plasma Spraying

Microstructure and Electrical Conductivity of Atmospheric Plasma-Sprayed LSM/YSZ Composite Cathode Materials

Breakthrough in Atmospheric Plasma Spraying of High-Density Composite Electrolytes: Deposition Behavior and Performance of Plasma-Sprayed GDC-LSGM on Porous Metal-Supported Solid Oxide Fuel Cells

Enhanced Sintering Behavior of LSGM Electrolyte and Its Performance for Solid Oxide Fuel Cells Deposited by Vacuum Cold Spray

Study on Properties of LSGM Electrolyte Made by Tape Casting Method and Applications in SOFC

Preparation and electrochemical characterization of Sr- and Mn-doped LaGaO 3 as anode materials for LSGM-based SOFCs

Microstructure and polarization of La 0.8Sr 0.2MnO 3 cathode deposited by alcohol solution precursor plasma spraying

Synthesis and Characterization of La0.9Sr0.1Ga0.8Mg0.2O3−δ Intermediate-Temperature Electrolyte Using Conventional Solid State Reaction

Structured La0.6Sr0.4Co0.2Fe0.8O3-δ cathode with large-scale vertical cracks by atmospheric laminar plasma spraying for IT-SOFCs