Abstract:Solid oxide fuel cells (SOFC) has attracted considerable attention in recent years as a power conversion system, owing to its high-energy conversion efficiency, fuel flexibility and low pollution emissions as well. Recently, the intermediate temperature-solid oxide fuel cell (IT-SOFC), which operates at lower temperatures (600~800 °C) to reduce cost and to improve efficiency, appears to be an alternative choice for the development of SOFC. La0.8Sr0.2Ga0.8Mg0.2O3 (LSGM), with a perovskite structure, presents a high ionic conductivity at intermediate temperatures. However, the common methods to fabricate the LSGM electrolyte (e.g., solid state method) often lose their advantages owing to the depletion of Ga and the interfacial reaction between the LSGM and electrodes. Vacuum cold spray (VCS), based on the impact adhesion of fine particles to build up ceramic film at room temperature, is a new and promising method to fabricate thin (﹤20 mm) and dense (LSGM) electrolyte membrane. In the present study, the LSGM electrolyte layer with a thickness of ~10 mm is prepared by a home-developed VCS system assisted with in-situ particle heating approach (25~400 °C). The output performance of cells assembled with VCS-LSGM is determined at 500~750 °C. Results show that the OCV value is above 1.0 V, suggesting that the VCS-LSGM electrolyte is dense enough for the application to SOFC. Meanwhile, the ionic conductivities of LSGM coatings prepared by different in-situ particle heating temperatures were determined by an electrochemical impedance spectroscopy system. In addition, the microstructure and phase structure of LSGM coatings was characterized by scanning electron microscopy and X-ray diffraction. Based on this study, it is possible to conclude that the VCS is a promising method to prepare the LSGM electrolyte applied in the IT-SOFC.

Study on Properties of LSGM Electrolyte Made by Tape Casting Method and Applications in SOFC

Recent progress in LaGaO3 based solid electrolyte for intermediate temperature SOFCs

Preparation and Properties of LSGM (Li/Na)(2)CO3 Composite Electrolytes for LT SOFC

Development by Mechanochemistry of La0.8Sr0.2Ga0.8Mg0.2O2.8 Electrolyte for SOFCs

Microstructure and Electrochemical Properties of La0.8Sr0.2Ga0.8Mg0.2O3 Thin Film Deposited by Vacuum Cold Spray for Solid Oxide Fuel Cells

Coupling of tape casting and in situ solid-state reaction for manufacturing La0.9Sr0.1Ga0.8Mg0.2O3 electrolyte of efficient solid oxide cells

APPLICATION OF LaGaO3-BASED OXYGEN-ION CONDUCTOR IN SOLID OXIDE FUEL CELL

Preparation and Performance of Large-Area La0.9Sr0.1Ga0.8Mg0.2O3−δ Electrolyte for Intermediate Temperature Solid Oxide Fuel Cell

Preparation and electrochemical characterization of Sr- and Mn-doped LaGaO 3 as anode materials for LSGM-based SOFCs

Application of High Velocity Oxygen Fuel Flame (HVOF) Spraying to Fabrication of La0.8Sr0.2Ga0.8Mg0.2O3 Electrolyte for Solid Oxide Fuel Cells

Enhanced Sintering Behavior of LSGM Electrolyte and Its Performance for Solid Oxide Fuel Cells Deposited by Vacuum Cold Spray

Microstructure and Electrical Conductivity of La10Si6O27–La0.9Sr0.1Ga0.8Mg0.2O2.85 Composite Electrolytes for SOFCs

Planar type reversible solid oxide cells using LaGaO 3 electrolyte thin-film prepared by dip-coating and co-sintering method

Preparation and Property of LSGM-Carbonate Composite Electrolyte for Low Temperature Solid Oxide Fuel Cell

Preparation of LaGaO_3 Based Electrolyte for Intermediate Temperature SOFC

LSGM-Carbonate Composite Electrolytes for Intermediate-Temperate SOFCs

La0.8Sr0.2Ga0.8Mg0.2O3 Electrolytes Prepared by Vacuum Cold Spray under Heated Gas for Improved Performance of SOFCs

Electrochemical Evaluation of La0.6Sr0.4Co0.8Fe0.2O3−δ–La0.9Sr0.1Ga0.8Mg0.2O3−δ Composite Cathodes for La0.9Sr0.1Ga0.8Mg0.2O3−δ Electrolyte SOFCs

Preparation and Performance of Anode-supported LaGaO<SUB>3</SUB>-based Electrolyte Solid Oxide Fuel Cells with Sm-doped CeO<SUB>2</SUB> Buffer Layers

Effect of Li2O Sintering Aid on Sintering Characteristics and Electrical Conductivity of LSGM Electrolyte for Solid Oxide Fuel Cell

Electrical and Stability Performance of Anode-Supported Solid Oxide Fuel Cells with Strontium- and Magnesium-Doped Lanthanum Gallate Thin Electrolyte