Abstract:This paper proposes an opto-electronic co- simulation method to evaluate a fast clock and data recovery (CDR) technique for optically switched data centers. The CDR technique is realized by leveraging a phase updating mechanism and also a global synchronous clock. Briefly, in all-optical networks, by applying a global synchronous clock to both transmitters and receivers, CDR will only need to extract phase delay in the receiver node, and then by compensating the phase delay in the transmitter node, the phase locking-process in RX CDR module can be omitted. This can significantly reduce the CDR locking time. The structure is crucial in supporting server-to-server optical communication but is not sufficiently studied in our perspective. In this paper, we add more analysis to the CDR technique and give circuit-level improvements. The analysis and circuit verifications are conducted by designing a novel opto-electronic co-simulation method, where software Opti-system is employed to carry out optical-related simulations, and MATLAB Simulink is employed to carry out electrical related simulations. We first test the validity of the phase updating mechanism with a specifically designed phase interpolator and a modified bang-bang phase detector. Then we analyze the influence of channel jitters and optical carrier power variations. It’s shown that the CDR technique can tolerate channel deterministic jitter and random jitter of 0.5UI and 0.1UI respectively, and can tolerate a carrier power variation from 0dBm to 2dBm.

System Design and Simulation of Write Clock Recovery for DVD Data

Design of All-digital Clock Recovery Unit Based on USB Device

Clock Recovery and Audio/Video Synchronization in Digital TV System

New Design of Clock Self Recovery Circuit Based on Time-to-voltage Conversion

Design and implementation of clock recovery system in DVB

A Novel Clock And Data Recovery Scheme Based On Sigma-Delta Quantization

A Novel Clock and Data Recovery Technique Based on Sigma-Delta Phase Quantization

Design and Implementation of a Rapid Synchronous Clock and Data Recovery Circuit

A speculative clock and data recovery architecture for multi-gigabit/s series links

Equalizer Design for Clock Recovery Based on Multi-Level Optical Disk Using Signal Waveform Modulation

Theoretical Modeling and Simulation of Phase-Locked Loop (PLL) for Clock Data Recovery (CDR)

Evaluation of a Subnanosecond Clock and Data Recovery Technique Via Matlab Simulink and Opti-System Co-Simulation

Design on Measurement System for Jitter of High-speed Optical Disc

180.5mbps-8gbps Dll-Based Clock And Data Recovery Circuit With Low Jitter Performance

Design of Jitter-Free Timing Recovery Scheme with Fast Tracking Capability for High Speed QAM Signal over HF Channel

Schemes of Clock Recovery and Synchronization in HDTV Decoder SoC

A statistical jitter tolerance estimation applied for clock and data recovery using oversampling

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition

An Improved Clock Cycle Measurement Method for High-Speed Serial Signal with Duty-Cycle-Distortion Jitter

Experimental Demonstration Of An All-Optical Clock And Data Recovery Technology For 10 Gb/S Nrz-Dpsk Signals

Delay‐locked Loop Based Clock and Data Recovery with Wide Operating Range and Low Jitter in a 65‐nm CMOS Process