Abstract:Low-alloy steels are constituted of twenty-four variants of lath martensite that exhibit gradients of orientations from Kurdjumov-Sachs (KS) to Nishiyama-Wassermann (NW). They are structured into four packets on each of the common close-packed plane {111}fcc// {110}bcc; and each packet is composed of three blocks constituted by pairs of low-misoriented variants. The habit planes reported in literature for this type of martensite are {557}fcc, but it is not clear whether they correspond to the laths or to the blocks. In this paper, we present crystallographic calculations proving that the average of the two KS distortions associated with the variants in a block is exactly a NW distortion. A new method of averaging distortion matrices was introduced for this purpose. It is also shown that the {575}fcc planes are let untilted by this NW distortion, and are thus good theoretical candidates for the observed habit planes. The predicted {575}fcc planes, however, do not contain any of the common close-packed directions of the two variants in the block, which is in apparent contradiction with the current view. In order to clarify this point, some Electron BackScatter Diffraction (EBSD) maps were acquired on different low-carbon steels; the prior austenitic grains were automatically reconstructed and the traces of the habit planes predicted by the different models were analyzed and compared to the morphologies. This experimental work shows that {575}fcc planes are the habit plane of the blocks, and that the habit plane of one block often dominates the others, which impedes to discriminate the different models. The advantages of our model are its simplicity, the absence of fitting parameters, and the symmetric role played by the variants the blocks.

LATTICE DISTORTION STORED ENERGY OF CRYSTALLOGRAPHIC ORIENTATIONS IN COLD-ROLLED LOW CARBON STEEL SHEETS

Effect of Crystallographic Orientation on Quenching Stress During Martensitic Phase Transformation of Carbon Steel Plate

Influence of Cold Rolling Reduction on the Deformation Behaviour and Crystallographic Orientation Development

Experimental investigation and simulation of crystallographic orientations evolution in a cold-rolled ultra-thin grain-oriented silicon steel

Crystal Plasticity Analysis of the Orientation-Dependent Grain Rotation and Fragmentation Behaviors in Ferritic Stainless Steel During Cold Rolling

3Dxrd Measurements of Lattice Rotations in Tensile Deformed if Steel

Strain Distribution Analysis Using Precise Markers in Cold-Rolled Ultra-Low Carbon Steel

Microstructural-Based Measurement of Local Stored Energy Variations in Deformed Metals

The Study of Tension/Compression Asymmetry of [111] Oriented Nickel Base Single Crystal Superalloys

ORIENTATIONAL INSPECTION OF FERRITE GRAINSDURING STRAIN ENHANCED TRANSFORMATION IN PLAIN CARBON STEEL Q235

Grain Orientation Dependence of Microstructures in a Warm Rolled IF Steel

Crystallite Orientation Analysis for a Multidirectionally Cold Rolled Α-Ti Alloy (TA7) Thin Sheet

Microstructural Dependence of Anisotropic Fracture Mechanisms in Cold-Drawn Pearlitic Steels

Lattice Rotation Dependence on Microstructural Characteristics in a Low Carbon Steel

Orientation Dependence of the Deformation Microstructure of Ta-4% W after Cold-Rolling

Deformation mechanism, orientation evolution and mechanical properties of annealed cross-rolled Mg-Zn-Zr-Y-Gd sheet during tension

A crystallographic model of the {557} habit planes in low-carbon martensitic steels

Inhomogeneities of Microstructures and Micro-Orientations in Cold-Rolled High Purity Al Columnar Grains

A Systematical Evaluation of the Crystallographic Orientation Relationship between MC Precipitates and Ferrite Matrix in HSLA Steels

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium