Abstract:The split Hopkinson pressure bar technique is extensively used to characterise material behaviour at high strain rates. In this paper, this technique is re-examined in order to optimise its accuracy, to improve its capacity and to develop innovating applications.The accuracy of the basic SHPB measurements which are forces and velocities at both sample faces is discussed and it depends on data processing which consists mostly of an accurate dispersion correction and of an exact delay setting. A deconvolution method is developed to increase measuring duration and consequently the maximum measurable strain.A one-dimensional numerical transient simulation of SHPB tests is used to analyse the validity of the average stress–strain curve obtained from measured forces and velocities. A fictitious specimen with a rate-sensitive behaviour described by a Sokolovsky–Malvern type constitutive model is used for this simulation. For the case where the classical SHPB analyses do not give acceptable results, an identification technique based on an inverse calculation method is presented. It permits relating material properties to forces and particle velocities measured at both faces of the specimen without using the assumption of axial uniformity of stresses and strains.Structural tests using a large SHPB, crushing of metallic tube for instance, can be performed in order to provide accurate data to validate identified constitutive laws. Simulations with commercial explicit code (Radioss) showing a good agreement with experimental data is also presented.

Experimental Study on Dynamic Mechanical Properties of Al2o3 Ceramics

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Compressive properties and failure mechanisms of AlON ceramics under different strain rates

Dynamic Response of Ceramic Shell for Titanium Investment Casting under High Strain-Rate SHPB Compression Load

Dynamic material property characterization by using split Hopkinson pressure bar (SHPB) technique

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Dynamic Brazilian Test of Brittle Materials Using the Split Hopkinson Pressure Bar and Digital Image Correlation

Dynamic Response Behaviours of Al2O3 Ceramics with Different Grain Sizes under SHPB Compression Loading

Research on dynamic mechanical properties and damage model of ceramic materials under multi‐axial stress

Rapid geometric characterization of ceramics fragments through split Hopkinson pressure bar tests

Study on Dynamic Mechanical Properties of Magnesium Alloy AZ61

High-temperature dynamic deformation of aluminum alloys using SHPB

Dynamic Behavior of Aluminum Alloy Aw 5005 Undergoing Interfacial Friction and Specimen Configuration in Split Hopkinson Pressure Bar System at High Strain Rates and Temperatures

Material behaviour characterisation using SHPB techniques, tests and simulations

Dynamic Plastic Experiments and Constitutive Model of 2024 Aluminum under High Temperature and High Strain Rate

The Influence of Specimen Geometry and Loading Conditions on the Mechanical Properties of Porous Brittle Media

Dynamic Anisotropic Behavior Of Amorphous Polymers

Experimental Study on Dynamic Mechanical Properties of a Mock PBX

Dynamic mechanical properties and failure mechanism of magnesium aluminum spinel based on experiments and peridynamic simulations

Fabrication and dynamic compressive response of reaction sintering H-BN ceramic

Analysis, Simulation and Experimental Study of the Tensile Stress Calibration of Ceramic Cylindrical Pressure Housings