Abstract:The high-strength and thin-walled shells are extremely beneficial for not only rapid solidification of metal castings but also excellent for shell removal, its low residual strength and low solid waste discharge. In this work, short carbon fibers as reinforcement were induced into the shells. The strength of specimens and their fracture behavior at ambient temperature or high temperature in loading were investigated using scanning electron microscopy (SEM) and thermogravimetric-differential scanning calorimetry technique (TG-DSC). The results show that the bending strength of the shell progressively rises initially and then decreases rapidly with increasing content of fiber with a constant length. In particular, the shell reinforced with 0.42 wt% carbon fibers of length of 2.0 mm reaches a peak of green strength of 4.68 MPa and a peak of hot strength 16.06 MPa, respectively, approximately 89.47 and 61.20% higher than that of the unreinforced. Moreover, the peak of the fired strength of shell specimens containing 0.51 wt% fibers of length of 3.0 mm reaches 7.48 MPa, increasing by 61.20% in comparison with the unreinforced. However, the high-temperature self-weight deformation of the shell does not reveal positive correlation or monotonically increasing with the amount of fiber. Furthermore, the results revealed that the fracture types and failure patterns of fibers in shells were mostly related to fiber-fracture, pull-out and/or debonding during loading. These research results are beneficial to further improve this technology and promote the practical application to greatly reduce the generation and discharge of waste shells in the production of investment castings in the future.

Dynamic Response of Ceramic Shell for Titanium Investment Casting under High Strain-Rate SHPB Compression Load

Microstructure Evolution and Mechanical Properties of Ceramic Shell Moulds for Investment Casting of Turbine Blades by Selective Laser Sintering

The Design of Testing Methods for Strength of Ceramic Shell Mold in Investment Casting

Effect of Ceramic and Nylon Fiber Content on Composite Silica Sol Slurry Properties and Bending Strength of Investment Casting Shell

An Experimental Characterization of Thermophysical Properties of a Porous Ceramic Shell Used in the Investment Casting Process

Strength Evolution and Fracture Feature of Carbon Fiber-Reinforced Silica Sol Shell for Investment Casting

Research on dynamic mechanical properties and damage model of ceramic materials under multi‐axial stress

Influence of Alkaline Oxide on the Deformation of Ceramic Shell Mould at High Temperatures During Investment Casting

Study on High-Strength Ceramic Shell of Expendable Pattern Casting

Microstructure Evolution and Mechanical Behaviors of Alumina-Based Ceramic Shell for Directional Solidification of Turbine Blades

Dynamic Response Behaviours of Al2O3 Ceramics with Different Grain Sizes under SHPB Compression Loading

Quantitative In-Situ Study of Strength-Governed Interfacial Failure Between H-Bn and Polymer-Derived Ceramic

Hydrostatic failure behavior of externally pressurized ceramic egg-shaped shells

Strength damage behavior analysis of silicon carbide(SiC) ceramic cylindrical shells under hydrostatic pressure based on the state-based peridynamics

Fracture Behavior of a High Pressure Die Casting AlSi10MnMg Alloy with Varied Porosity Levels

Effect of Sintering Temperature on Microstructure and Mechanical Behavior of Alumina-Based Ceramic Shell by SLS

A Shockless Plate-Impact Spalling Technique, Based on Wavy-Machined Flyer-Plates, to Evaluate the Strain-Rate Sensitivity of Ceramic Tensile Strength

High temperature behavior of silica sol shell and its influencing factors

Dynamic mechanical behavior and damage properties of SHCC under high strain rate loading

Performance Evolution and Fracture Features of Sodium Silicate Shell Cured via Droplet-Based Microfluidics of Acetic Acid

Effect of silica sol on performance and surface precision of alumina ceramic shell prepared by binder jetting