Abstract:<p>To investigate the separation mechanism of a vane-type separator, a flow experiment and a numerical simulation were conducted. Electrical resistance tomography and Coriolis mass flow meters were used during the flow experiment. An Eulerian multiphase model coupled with the Reynolds stress turbulent model was applied to conduct a corresponding numerical simulation. Based on the phase, the velocity, and the swirling intensity distribution, the separation performance of the separator was discussed in terms of the separation efficiency, the entrainment ratio, and the critical split ratio. Results showed that the swirling intensity was sensitive to the separator geometry and operating parameters. The separation efficiency increased with the split ratio under fixed entrance conditions. Once the split ratio was larger than the critical split ratio, the gas phase collected becomes maximal with a larger liquid phase collected in the branch exit if the split ratio increased continuously. Subsequently, based on the definition of split flow face, the gas–liquid separation mechanism was revealed by discussing the relative location of the gas–liquid interface and the split flow face. Finally, the relationships among the operating parameters including the exit pressure difference, the split ratio, and the liquid phase flow rate were analyzed based on the proposed separation mechanism model. This study provides a better understanding of the vane-type gas–liquid separation procedure and optimization.</p>

Performance Investigation of Double V Type Inertia Separator

Numerical Simulation and Experimental Investigation of Flow Field in Gas-Liquid Cylindrical Separator with Baffle Configuration

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Experimental Study of the Separation Performance of a Square Separator Assuming a Horizontal Heat Exchange Mode

Analysis and Improvement of the Profile of an Inertia Particle Separator

Double-Eccentric Design for the Vortex Finder of a Cyclone Separator

Numerical Simulation on the Performance of Axial Vane Type Gas-Liquid Separator with Different Guide Vane Structure

NUMERICAL STUDY ON SWIRLING FLOW AND SEPARATION PERFORMANCE OF SWIRL VANE SEPARATOR

Emulation and experimental research on separation characteristics of piston-type separator

Characteristics of Gas Flow Field and Separation Efficiency of Two Venturi Separators with Different Structure

Performance Investigation and Optimization of the Primary Separation Part of the Oil-Gas Separator

Numerical Simulation on Double Moisture Removal Suction Slots

Study of the separation efficiency of a demister vane with response surface methodology

Separation mechanism and influential factor study on vane-type-associated petroleum gas separator

Numerical Investigation of Effects of Turbulence Intensity on Aerodynamic Performance for Straight-Bladed Vertical-Axis Wind Turbines

CFD Investigation on the Performance of Cyclone Separators with Divergent or Convergent Insertion Pipes

Effect of Internally Mounted Helical Fins on the Separation Performance of a Cylindrical Gas-Solid Cyclone Separator

Effect of double inclined slotted casing treatment on centrifugal compressor performance

Experimental Research on the Performance of a Cyclone Impeller Type Separator

Numerical Investigation to Performance of Centrifugal Impeller with Vortex Generator Jets

Numerical Research on a Double Suction Centrifugal Fan