Abstract:Boron (B), normally present in ground water and sea water, is a vital micronutrient for plants, but is also toxic in excessive amounts. Under typical conditions, aqueous boron is present as boric acid (H3BO3), which is uncharged, making B particularly challenging to remove by mechanisms commonly applicable to removal of trace constituents. Adsorption of B onto aluminum hydroxide solids (Al(OH)3(s)) generated using aluminum-based electrocoagulation (EC) is a promising strategy for B removal. Infrared spectroscopy analysis indicated complexation of B(OH)3 with aluminum hydroxide solids via surface hydroxyl groups, while X-ray and infrared spectroscopy results indicated that the structure of the Al(OH)3(s) was influenced both by EC operating conditions and by water quality. A linear adsorption model predicted B removal well when initial concentrations were lower than 50 mg/L, but fit the experimental data poorly at higher initial B concentrations. The Langmuir adsorption model provided a good fit for a broader range of initial B concentrations (5-1000 mg/L). Factors affecting B adsorption during the EC process, including current intensity, Al dissolution rate, boron concentration, pH, and total dissolved solid (TDS), were investigated. Increasing current intensity initially led to a higher Al dissolution rate, and therefore higher B adsorption, but there was a limit, as further increases in current intensity caused rapid formation of Al(OH)3(s) having a large particle size and a low capacity to complex B. Boron removal decreased as its concentration increased. The best removal of B occurred at pH 8, corresponding to a slightly positive zeta potential for aluminum hydroxide and a small but significant fraction of negatively charged B species. Higher TDS concentrations facilitated the use of higher current intensities, i.e., the limit on the effective Al dissolution rate increased with increasing TDS. Two real water samples (river water and oilfield produced water) spiked with B were treated using EC, resulting in up to 50% B removal from river water (C0 = 10 mg/L, current = 0.2 A) in 2 h, and 80% B removal from produced water (C0 = 50 mg/L, current = 1.0 A) in 2 h.

Study on Elimination of Barium in Extract from Bubali Cornu

Treatment of hexavalent chromium-containing electroplating wastewater by barium salt precipitation

Dissolution of Barium from Barite in Sewage Sludges and Cultures of Desulfovibrio desulfuricans

Non-hazardous Treatment for Barium Slag Using Phosphogypsum

Evaluation of the Extraction Efficiency of Heavy Metals (pb, Cd, Cu) in Soil–Bayberry System

Co-removal and recycling of Ba2+ and Ca2+ in hypersaline wastewater based on the microbially induced carbonate precipitation technique: Overlooked Ba2+ in extracellular and intracellular vaterite

Treatment of acidic lead-containing wastewater by depositing together with barium salt

Elimination Of The Spectral Interference From Barium Polyatomic Ions On Rare Earth Elements In Inductively Coupled Plasma Mass Spectrometry By Ag50w-X8 Cation Exchange Chromatographic Separation

Boron Removal in Aqueous Solutions Using Adsorption with Sugarcane Bagasse Biochar and Ammonia Nanobubbles

Efficient separation and recovery of barium from barium slag via hydrometallurgical approach: Process design, thermodynamics research and mechanism investigation

Discussion on spectrometry of barium sulfate content in negative active materials

Determination of Anion Impurities in Barium Carbonate by Ion Chromatography with Membrane Treatment

Study on the Method of Nanometer-Size Zirconium Dioxide Enrichment Separation and Inductively Coupled Plasma Mass Spectrometry Determination of Trace Barium(Ii) in Water

Removal of Pb(II) from water using nanoscale SBA-15

Removal of impurities from bismuth pickling solution using solvent extraction with TBP

Effect Analysis of Removing Lead and Arsenic from Contaminated Soil by Selected Eluents

Boron removal by electrocoagulation: Removal mechanism, adsorption models and factors influencing removal

Effect of Ba2+ on the biomineralization of Ca2+ and Mg2+ ions induced by Bacillus licheniformis

Solution-chemistry Analysis of Ammonium Bicarbonate Consumption in Rare-Earth-element Precipitation

A single column separation method for barium isotope analysis of geologic and hydrologic materials with complex matrices

A comparative study of removal of Cu(II) from aqueous solutions by locally low-cost materials: marine macroalgae and agricultural by-products