Abstract:To separate Mo(VI) and Zr(IV) ions from a 0.5 M oxalic acid solution and from each other, a novel macroporous silica-based N,N,N′,N′- tetraoctyl-3-oxapentane-1,5-diamide (TODGA) chelating polymeric adsorbent (TODGA/SiO 2 -P) was synthesized by introducing the TODGA molecule into ca. 50-μm diameter SiO 2 -P particles by impregnation. The adsorption of Mo(VI) and Zr(IV) ions onto TODGA/SiO 2 -P was investigated by examining the influence of nitric acid and oxalic acid concentrations. It was found that the adsorption was strongly affected by increasing the HNO 3 concentration from 0.5 M to 9.0 M either with or without the addition of 0.5 M H 2 C 2 O 4 . In the absence of 0.5 M H 2 C 2 O 4 , the distribution coefficients (K d ) of both Mo(VI) and Zr(IV) ions decreased with an increase in the HNO 3 concentration from 0.5 M to 3.0 M, increased slowly when the concentration of HNO 3 was increased further from 3.0 M to 6.0 M, and then increased gradually above 6.0 M concentration. Furthermore, the adsorption of Zn(IV) ions onto TODGA/SiO 2 -P was considerably greater than that of Mo(VI) ions. In the presence of 0.5 M H 2 C 2 O 4 , Zr(IV) ions showed no adsorption at HNO 3 concentrations below 4.0 M, being partly adsorbed in the presence of 4.0–6.0 M HNO 3 and fully adsorbed when the HNO 3 concentration was greater than 6.0 M. In contrast, Mo(VI) ions showed a much lower adsorption at HNO 3 concentrations below 2.0 M and no adsorption above this acid level. In the presence of HNO 3 at a concentration above 6.0 M and containing 0.5 M H 2 C 2 O 4 , the adsorption of Zr(IV) ions overlapped that from a similar HNO 3 solution which did not include 0.5 M H 2 C 2 O 4 . This was attributed to complete protonation of the C 2 O 2− 2 anion. On the basis of batch experiments, Mo(VI) and Zr(IV) ions were separated from a 6.5 M HNO 3 solution containing 0.5 M H 2 C 2 O 4 by means of a column packed with TODGA/SiO 2 -P at 50°C. The separate components, Mo(VI) and Zr(IV), could be effectively separated from each other by eluting with some selected eluants. The recovery percentage was 100.5% for Mo(VI) ions and 96.8% for Zr(IV) ions.

Study on the Method of Nanometer-Size Zirconium Dioxide Enrichment Separation and Inductively Coupled Plasma Mass Spectrometry Determination of Trace Barium(Ii) in Water

Chromatographic Separation of Strontium (II) from a Nitric Acid Solution Containing Some Typically Simulated Elements by a Novel Silica‐Based TODGA Impregnated Polymeric Composite in the MAREC Process

SPEC Process II. Adsorption of Strontium and Some Typical Co-Existent Elements Contained in High Level Liquid Waste Onto a Macroporous Silica-Based Crown Ether Impregnated Functional Composite

Adsorption and Chromatographic Separation of Mo(VI) and Zr(IV) Ions from a High-Concentration Oxalic Acid Solution by a Macroporous Silica-Based N,N,N′,N′-Tetraoctyl-3-Oxapentane-1,5-Diamide Polymeric Adsorbent

Adsorption and separation of Cs(I) and Ba(II) from aqueous solution using zinc ferrite-humic acid nanocomposite

Removal Of Antimonite (Sb(Iii)) And Antimonate (Sb(V)) From Aqueous Solution Using Carbon Nanofibers That Are Decorated With Zirconium Oxide (Zro2)

Synthesis of magnetic zirconium oxide-iron oxide nanoparticles composite using chemical precipitation process for Pb (II) adsorption

Adsorption of Pb2+onto zirconia functionalized carbon-based magnetic nanocomposites

Silica-gel Particles Loaded with an Ionic Liquid for Separation of Zr(IV) Prior to Its Determination by ICP-OES

Simultaneous preconcentration and determination of zirconium in environmental samples using ultrasound-assisted ionic liquid based dispersive liquid-liquid microextraction combined with spectrophotometry

arium isotope measurements by MC-ICP-MS

High-precision barium isotope measurements by MC-ICP-MS

Determination of niobium, tantalum, zirconium and hafnium in geological materials by extraction chromatography and inductively coupled plasma mass spectrometry

Adsorption on UiO-66 for preconcentration, matrix separation, slurry sampling and in situ hydride generation-atomic fluorescence spectrometric determination of trace bismuth in alloy and water

Anchoring Nanoscale Zero-Valent Iron Within Bacterial Cellulose Particles for Boosting Efficient Adsorption of Co(II) and Sr(II) from Seawater: Dual System and Varying Adsorption Mechanisms

Determining Ba Isotopes of Barite Using the Na2CO3 Exchange Reaction and Double-Spike Method by MC-ICP-MS

A single column separation method for barium isotope analysis of geologic and hydrologic materials with complex matrices

Mechanistic study on boron adsorption and isotopic separation with magnetic magnetite nanoparticles

A facile synthesis of nanosheet-structured barium carbonate spheres with a superior adsorption capacity for Cr(VI) removal

Experiments on two techniques for the removal of barite from detrital zircon

Low-temperature Synthesis and Analysis of Barium Titanate Nanoparticles with Excess Barium