Abstract:Fibre-reinforced high-performance fly ash foam concrete (FHFC) has broad engineering application prospects owing to its lightweight and high-strength, energy-saving, heat preservation and environmental protection characteristics. Its mechanical properties and constitutive models can serve as an important basis for engineering structural design, numerical analysis and structural reliability monitoring. Aimed at exploring the influence of different factors on the physical and mechanical properties of FHFC and its stress–strain constitutive relationship, the dry density, cube compressive strength, splitting tensile strength and axial compressive strength of 27 groups of FHFC with different mixture proportions were measured and analysed. The primary and secondary relationships of the water–binder ratio, sand–binder ratio and replacement rate of fly ash to cement on the physical and mechanical properties of FHFC were studied. The failure mechanism of FHFC under uniaxial compression was discussed and a two-stage phenomenological constitutive model of FHFC was established through theoretical derivation. The results show that sand–binder ratio and water–binder ratio are the main factors affecting the physical and mechanical properties of FHFC. The stress–strain curve shows the characteristics of stages, namely, the elastic–plastic stage, the stress upswing stage, the plastic plateau stage and the failure stage. The influence of each factor on the elastic–plastic stage of the stress–strain curve shows obvious regularity, but the influence on the plastic stage is complex, and the regularity is not significant. The established two-stage phenomenological constitutive model is in good agreement with the stress–strain curve obtained from the test, and it can more accurately predict the uniaxial compression response of FHFC. The model can be used for the theoretical calculation of the bearing capacity of high-strength foam concrete structural members and even serve as an important basis for the engineering application of high-strength foam concrete. The influences of various factors on the performance of fibre-reinforced high-performance fly ash foam concrete were investigated. The uniaxial compression failure mechanism and stress–strain curve of fibre-reinforced high-performance fly ash foam concrete in different test groups were analysed. A two-stage phenomenological constitutive model suitable for fibre-reinforced high-performance fly ash foam concrete was established.

Experimental Study of Mechanical Properties of Small-sized Hollow Fly-ash Confined Masonry

Experimental Study on Mechanical Properties of Basalt Fiber-Clay Lime Mortar and Application in Brick Masonry

Experiment and simulation for constitutive relationship of autoclaved fly ash brick masonry

Experimental Study on Shear Behavior of Autoclaved Fly Ash Brick Masonry

EXPERIMENTAL STUDY ON BASIC MECHANICAL BEHAVIOR OF A NEW TYPE CONCRETE HORIZONTAL-HOLE HOLLOW BLOCK MASONRY

Experimental Study on Basic Mechanical Properties of Core-Column Non-mortar Aerated Concrete Block Masonry

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Experimental Study of Masonry Walls Strengthened with Cfrp

Research on the Compression Behavior of a New Type of Concrete Horizontal-hole Hollow Block Masonry

Influence of Mineral Admixture on Early-Age Concrete Cracking

Mechanical properties and constitutive model of fibre-reinforced high-performance class-F fly ash foam concrete

Experimental Research on Shear Performance of Reinforced Block Short-Leg Masonry Shear Wall

Experimental Study of Strength Characteristics of Foam Concrete

Mechanical Properties of a New Type Recycled Aggregate Concrete Interlocking Hollow Block Masonry

Preparation of Fly Ash-based Lightweight Loadbearing Wall Materials: an Experimental Study

Investigation on Hydration and Mechanical Properties of Mortar Containing Limestone Powder and Fly Ash Based on the Coupled Chemical–Thermal–Mechanical Method

Mechanical Properties of Composite Mortar for Residential Drick Walls

AXIAL COMPRESSIVE TEST AND ANALYSIS OF PREFABRICATED HOLLOW SHEAR WALLS

Impact of particle size of fly ash on the early compressive strength of concrete: Experimental investigation and modelling

Experimental study on compressive behavior of green chain block masonry

Mixture Design and Mechanical Properties of Recycled Mortar and Fully Recycled Aggregate Concrete Incorporated with Fly Ash