Abstract:Fibre-reinforced high-performance fly ash foam concrete (FHFC) has broad engineering application prospects owing to its lightweight and high-strength, energy-saving, heat preservation and environmental protection characteristics. Its mechanical properties and constitutive models can serve as an important basis for engineering structural design, numerical analysis and structural reliability monitoring. Aimed at exploring the influence of different factors on the physical and mechanical properties of FHFC and its stress–strain constitutive relationship, the dry density, cube compressive strength, splitting tensile strength and axial compressive strength of 27 groups of FHFC with different mixture proportions were measured and analysed. The primary and secondary relationships of the water–binder ratio, sand–binder ratio and replacement rate of fly ash to cement on the physical and mechanical properties of FHFC were studied. The failure mechanism of FHFC under uniaxial compression was discussed and a two-stage phenomenological constitutive model of FHFC was established through theoretical derivation. The results show that sand–binder ratio and water–binder ratio are the main factors affecting the physical and mechanical properties of FHFC. The stress–strain curve shows the characteristics of stages, namely, the elastic–plastic stage, the stress upswing stage, the plastic plateau stage and the failure stage. The influence of each factor on the elastic–plastic stage of the stress–strain curve shows obvious regularity, but the influence on the plastic stage is complex, and the regularity is not significant. The established two-stage phenomenological constitutive model is in good agreement with the stress–strain curve obtained from the test, and it can more accurately predict the uniaxial compression response of FHFC. The model can be used for the theoretical calculation of the bearing capacity of high-strength foam concrete structural members and even serve as an important basis for the engineering application of high-strength foam concrete. The influences of various factors on the performance of fibre-reinforced high-performance fly ash foam concrete were investigated. The uniaxial compression failure mechanism and stress–strain curve of fibre-reinforced high-performance fly ash foam concrete in different test groups were analysed. A two-stage phenomenological constitutive model suitable for fibre-reinforced high-performance fly ash foam concrete was established.

Experiment and simulation for constitutive relationship of autoclaved fly ash brick masonry

EXPERIMENTAL RESEARCH ON STABILIZATION OF RED CLAY WITH CEMENT AND FLYASH

Behavior of FRP-Confined Recycled Brick Aggregate Concrete under Monotonic Compression

Experimental Study on Shear Behavior of Autoclaved Fly Ash Brick Masonry

Experimental determination and fractal modeling of the effective thermal conductivity of autoclaved aerated concrete: Effects of moisture content

EFFECT OF MASONRY MORTAR ON THERMAL INSULATION OF AAC MASONRY

Experimental Study on Mechanical Properties of Basalt Fiber-Clay Lime Mortar and Application in Brick Masonry

Study of Mechanics Behavior and Constitutive Model of Cemented Soil under Static Triaxial Tests

An Experimental Investigation of Mechanical Properties in Clay Brick Masonry by Partial Replacement of Fine Aggregate with Clay Brick Waste

Investigating the confinement effects on masonry behavior based on friction interface

Influence of Mineral Admixture on Early-Age Concrete Cracking

Experimental Study on Basic Mechanical Properties of Core-Column Non-mortar Aerated Concrete Block Masonry

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

Nonlinear FEM analysis of autoclaved aerated concrete block composite masonry walls

Application Research of In Situ Axial Compression Method on Brick Masonry

Analysis of Chinese ancient brick masonry characteristics under uniaxial compression fatigue loading

Mechanical properties and constitutive model of fibre-reinforced high-performance class-F fly ash foam concrete

The Relationship of Compressive Strength and Chemically Bound Water Content of High-Volume Fly Ash-Cement Mortar

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Investigation on Hydration and Mechanical Properties of Mortar Containing Limestone Powder and Fly Ash Based on the Coupled Chemical–Thermal–Mechanical Method

A comparative analysis of compression bearing capacity in recycled concrete brick walls and composite walls incorporating coal-ash blocks