Abstract:In the face of the problem of waste disposal in the demolition of concrete structures, a composite wall composed of recycled concrete bricks and fly ash blocks was proposed, and based on the previous thermal performance research, its axial compression performance were further studied. Four types of walls were designed and constructed: (1) clay brick masonry (CBM), (2) recycled concrete brick masonry (RBM), (3) bilateral clay bricks masonry with coal-ash blocks sandwich insulation wall (CFCM), and (4) bilateral recycled concrete bricks masonry with coal-ash blocks sandwich insulation wall (RFRM). The test results showed that recycled concrete brick masonry exhibited a higher bearing capacity than clay brick masonry. The ultimate load of RBM was 15% higher than that of CBM. Moreover, the ultimate load of CFCM was 21% higher than that of CBM. Following the addition of sandwich coal-ash blocks in RBM, its ultimate load increased by over 42% than that of CBM. Following the addition of coal-ash blocks sandwich in both clay and recycled concrete bricks masonry, both the bearing capacity and strain exhibited improvement, the yielding load and compressive strength of them increased. Thus, it could be concluded that coal-ash blocks improved its bearing capacity. Based on the analysis of the axial compression tests, a theoretical computational model was developed and a computational expression to explain the compressive bearing capacity of a two-sided brick with coal-ash blocks sandwich insulation wall. Comparisons between the test ultimate loads (FT) and the estimated ultimate loads (FE) confirmed the accuracy of the theoretical calculation model for the compressive bearing capacity. Thus, theoretical computational models are highly recommended for the design of two-sided bricks with insulating walls constructed from coal-ash blocks being sandwiched together. This study provides a theoretical basis for the engineering application of recycled concrete brick wall and fly ash block composite wall.

Experimental Study on Shear Behavior of Autoclaved Fly Ash Brick Masonry

Experimental Study on Mechanical Properties of Basalt Fiber-Clay Lime Mortar and Application in Brick Masonry

Behavior of FRP-Confined Recycled Brick Aggregate Concrete under Monotonic Compression

Experiment and simulation for constitutive relationship of autoclaved fly ash brick masonry

EFFECT OF MASONRY MORTAR ON THERMAL INSULATION OF AAC MASONRY

Experimental Study on Low Strength Brick Masonry Wall Strengthened with Self-compacting Concrete Wall

Experimental Study on Basic Mechanical Properties of Core-Column Non-mortar Aerated Concrete Block Masonry

Quasi-static, Cyclic Loading Tests of RAC Brick Masonry Walls Strengthened by Basalt Textile Reinforced Concrete

Influence of Mineral Admixture on Early-Age Concrete Cracking

On the Seismic Performance of Autoclaved Aerated Concrete Self-Insulation Block Walls

Application Research of In Situ Axial Compression Method on Brick Masonry

A comparative analysis of compression bearing capacity in recycled concrete brick walls and composite walls incorporating coal-ash blocks

EXPERIMENTAL INVESTIGATION ON CONCRETE PERFORATED BRICK WALL SHINKAGE AT DIFFERENT AGES

Study on the shear properties of masonry pagoda mortar and its influencing factors

Research of the combined effects by temperature action and the loads on the block masonry structure

Comparison of Influence of Superficial Strengthening with FRCM System and Kind of Mortar Type on Shear Strength of Autoclaved Aerated Concrete Masonry

Mechanical Properties of a New Type Recycled Aggregate Concrete Interlocking Hollow Block Masonry

Analysis of Chinese ancient brick masonry characteristics under uniaxial compression fatigue loading

Study on Preparation of Decarburized Fly Ash-phosphogypsum Autoclaved Brick

Nonlinear FEM analysis of autoclaved aerated concrete block composite masonry walls

Effect of Moisture Condition of Brick–Concrete Recycled Coarse Aggregate on the Properties of Concrete