Abstract:Temperature is one of the critical factors that strongly affect the behavior of hydrogen isotopes in tungsten (W). This work investigates the effect of initial exposure temperature on the deuterium (D) retention and surface blistering in recrystallized W. D plasma exposure is started at 420 K and 600 K, respectively, and then changed to the same temperature of 520 K. For each temperature, the irradiation fluence is ∼ 1 × 1026 D m−2, and therefore the total fluence is ∼ 2 × 1026 D m−2 for each sample. A reference W sample was also exposed at 520 K with the same total fluence. Compared with the reference sample, it is found that the initial temperature of 420 K significantly inhibits the formation of intergranular blisters and leads to a reduction of intragranular blisters in size. Although the initial temperature of 600 K facilitates the formation of intergranular blisters, the intergranular blister size is reduced. This is possibly related to the relatively higher concentration of trapped D over a large depth range as revealed by the TMAP simulation results, leading to the fact that intergranular cracks are more prone to propagate along sloping grain boundaries. Thermal desorption spectra results show that the initial exposure temperature of 420 K and 600 K reduce D retention by a factor of ∼ 56 % and ∼ 34 %, respectively. It is considered to be connected with the blistering-induced defects and D transport in W, which are strongly affected by the initial exposure temperature. This work demonstrates that the initial exposure temperature plays a crucial role in D behavior in W, improving the understanding of the temperature effects of hydrogen isotopes behavior in W.

Temperature Dependence of Retention of Energetic Deuterium and Carbon Simultaneously Implanted into Tungsten

Trapping behaviour of deuterium ions implanted into tungsten simultaneously with carbon ions

Dynamics Of Hydrogen Isotope Trapping And Detrapping For Tungsten Under Simultaneous Triple Ion (C+, D-2(+) And He+) Implantation

Deuterium Retention in Tungsten Films Deposited by Magnetron Sputtering

Correlation Between Deuterium Retention and Microstructure Change for Tungsten under Triple Ion Implantation

Combination of in-situ ion beam analysis and thermal desorption spectroscopy for studying deuterium implanted in tungsten

Deuterium Retention in Tungsten-Doped Amorphous Carbon Films Exposed to Deuterium Plasma

Influence of nitrogen pre-implantation on deuterium retention in tungsten

Chemical States and Deuterium Retention Behavior of Vacuum Plasma Sprayed Tungsten Coatings

Effects of Tantalum Alloying on Surface Morphology and Deuterium Retention in Tungsten Exposed to Deuterium Plasma

Deuterium Retention in SiC Coated Graphite by D2+ Implantation

Correlation Between Desorption of Deuterium and Recovery of Irradiation Defects in Simultaneously Deuterium and Carbon Ion-Implanted Tungsten

Influence of Nitrogen Pre-Irradiation at Different Temperatures on Surface Blistering and Deuterium Retention in Tungsten

Effect of initial exposure temperature on the deuterium retention and surface blistering in tungsten

Hydrogen retention and affecting factors in rolled tungsten: Thermal desorption spectra and molecular dynamics simulations

Retention Behavior Of Deuterium And Oxygen In Boronized Vps-W

Deuterium retention and thermal conductivity in ion-beam displacement-damaged tungsten

Surface morphology and deuterium retention in tungsten exposed to high flux D plasma at high temperatures

Influence of annealing and keV-ion implantation into tungsten on deuterium retention and permeation: The dependence on bulk and surface microstructure

Deuterium Irradiation Resistance and Relevant Mechanism in W–ZrC/Sc2O3 Composites Prepared by Spark Plasma Sintering

Blistering Behavior and Deuterium Retention in Tungsten Vanadium Alloys Exposed to Deuterium Plasma in the Linear Plasma Device STEP