Abstract:The deformation behavior of sheet metal is currently presented by the stress-strain curve, which gives the variation of flow stress as strain increases. The correlation between stress and strain is also used to characterize the material hardening under different stress states. For anisotropic materials, the deformation behavior depends on stress state, and it is important to realize similar deformation conditions to obtain the stress-strain relationship. In this article, the profile of the free bulging zone was described by a tangent circle model during tube bulging test with fixed ends. In conjunction with the newly suggested linear-model for instantaneous thickness at the middle point, an analytical model and testing method is developed to establish the equivalent stress-equivalent strain relation of tubes. Experiments of STKM11A steel tube have been carried out, and different yield criteria are adopted to define the equivalent stress and equivalent strain. The effect of the anisotropic parameters on the mechanical property is analyzed. Results show that the profile of the free bulging zone can be well reproduced by the tangent circle model for practical application, and the analytical model and data measuring method for the bulging test can be simplified. The equivalent stress-equivalent strain curve by bulging test is rather different from that by uniaxial tension test, with a lower equivalent stress in the initial yielding stage and a greater rate of the equivalent stress increasing with the increase of the equivalent strain. In addition, the shorter the bulging zone length is, the greater the maximum equivalent strain is, because equal-biaxial stress state is approached. As the axial stress is significantly smaller than the hoop stress in bulging test, the anisotropic parameter along the hoop direction has a stronger effect on the determined curve and should be determined precisely.

On the Study of Stress-Strain of Thin-Walled Cylinder Tensile Specimens at High Temperature

Tensile and Fatigue Behavior of Thin-Walled Cylindrical Specimens under Temperature Gradient Condition

Experiment and Theory Investigation on Tension Behavior of Thin-walled Cylindrical Specimen at Temperature Gradient

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

A New Method of Tensile Performance Testing for Materials at High Temperature and High Strain Rate

Validity analysis of materials' dynamic tensile SHTB experimental technique at ultrahigh temperature

The Effect of Temperature Field on Stress Distribution of Cylinder Head

STUDY ON TENSILE PROPERTIES OF N18 ZIRCALOY

Elastoplastic Finite Element Analysis of Smoothing Specimen under Multiaxial Cycle Loading

An experimental investigation of large-strain tensile behavior of a metal sheet

A Tensile Characterization Study of Metal Sheet in Large-Strain

Analytical Model and Testing Method for Equivalent Stress-Strain Relation of Anisotropic Thin-Walled Steel Tube

Temperature Field And Thermal Stress Analysis Of The Cylinder Component Under High Temperature And Pressure Impact

Simplified method to identify full von Mises stress-strain curve of structural metals

Experimental investigation of thin-walled sorbite stainless steel material at elevated temperatures

Influence of Stress Triaxiality on the Failure Behavior of Ti-6Al-4V Alloy under a Broad Range of Strain Rates

Inverse Identification Method for Determining Stress–strain Curves of Sheet Metals at High Temperatures

Experimental Study on Multi-Necking Phenomenon of Tensile Metal Specimen

Effect of Different Temperature and Strain Rates on Thin Plate Aluminum Alloy LY12CZ

Effects Of Temperature And Strain Rate On The Fracture Behaviors Of An Al-Zn-Mg-Cu Alloy

Influence of Specimen Thickness with Rectangular Cross-Section on the Tensile Properties of Structural Steels