Abstract:The main objective of the present article is to obtain the optimum technological parameters of the automobile plastic front-end frame. Moldflow software was used to simulate the injection molding of the automobile plastic front-end frame bracket in this study. The uniformity experiment was designed and completed. Five injection molding process parameters, including mold temperature, melt temperature, packing pressure, injection time, and packing time, were selected as experimental factors. Volume shrinkage and warpage amount were selected as quality evaluation indexes. Statistical Product Service Solutions (SPSS) software was used to perform linear regression analysis on the test results, respectively, and the linear regression equation corresponding to the two evaluation indexes was obtained. Then, regression equation analysis was carried out to obtain the optimal process parameter combination of the volume shrinkage and the warpage amount. A back propagation (BP) neural network model with input as a process parameter and output as an evaluation index is established by MATLAB and optimized by a genetic algorithm (GA). Finally, the optimized neural network model was used to predict the combination of process parameters with the minimum volume shrinkage and warpage amount. Based on the performed simulations, the minimum volume shrinkage and the minimum amount of warping in the optimal design were 13% and 0.7062 mm, respectively. The corresponding combination of process parameters was the mold temperature of 75.5°C, the melt temperature of 285.32°C, the packing pressure of 42.32 MPa, the injection time of 3.45 s, and the packing time of 60 s. According to the optimal process parameters, the volume shrinkage and warpage amount of the automobile plastic front-end frame have reached the optimal state at the same time, which improves the quality of injection molding and reduces production and processing costs. It has a certain guiding significance.

Research on the Gas-assisted Injection Molding of the Box Shape Plastic Parts Based on 2.5D Numerical Simulation

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Soft Computing Applied to Gas-Assisted Injection Molding Process Optimization

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Optimization of the gas-assisted injection moulding process using multiple gas-injection systems

Research on Lightweight Injection Molding (CAE) and Numerical Simulation Calculate of New Energy Vehicle

Study of injection molding process simulation and mold design of automotive back door panel

Research on Optimization of Injection Molding Process Parameters of Automobile Plastic Front-End Frame

Factors Affecting the Stability of Gas Penetration in Gas Assist Injection Molded Bifurcation Parts

Influence of gas counter pressure injection molding parameters on shrinkage ratio of plastic part

Research on the Application of Injection Molding Simulation Technology in Mold Design

Research on the Effects of Process Parameters on Shrinkage Variation of the Rapid Heat Cycle Molding Plastic Part

Application of CAE in Gas-Assisted Injection Molding for Car Dashboards

The Influential Effect of Molding Parameters on Quality of Part Manufactured by Rapid Heat Cycle Molding Technology

Simulation and Experimental Study on the Precision Molding of Irregular Vehicle Glass Components

3D Modeling in Injection Molding Seat and Optimization of Its Process Parameters

Intelligent Methods for the Process Parameter Determination of Plastic Injection Molding

CAE Optimization Analysis of Injection Process Parameters for the Moulding of Air Conditioner Bracket

Design and Parametric Optimization of the Injection Molding Process Using Statistical Analysis and Numerical Simulation

Effective fast-response pressure control for thin-wall gas-assisted injection molding

Optimization of the Compression (Injection/Compression) Molding Process Using Numerical Simulation