Abstract:It is a typical gas–liquid two phase flow phenomenon that gas penetrates the polymer melt in gas-assisted injection molding (GAIM) process. Numerical simulation is now playing an important role in GAIM, in which the accurate simulation of moving interface is of great importance. The level set (LS) method is a popular interface tracking method, but it does not ensure naturally mass-conservation. In order to improve the mass-conservation of LS method, a coupled level-set and volume-of-fluid (CLSVOF) method with mass-correction is presented for the numerical simulations of interfacial flows in GAIM. The performance of this CLSVOF method is demonstrated by two numerical tests including the three-dimensional deformation field test and the dam break problems. Finally the CLSVOF method is employed to simulate the 3D moving interfaces in GAIM, including gas–melt interface and the melt-front interface. The influences of melt temperature and gas delay time are also analyzed detailedly. As a case study, the processes that gas penetrates the polymer melt in complex cavities are also simulated using this method, and the simulation results are in agreement with those obtained by other researchers.

Optimization of the gas-assisted injection moulding process using multiple gas-injection systems

Soft Computing Applied to Gas-Assisted Injection Molding Process Optimization

Numerical Simulation of Gas-Assisted Injection Molding Process for A Door Handle

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Multi-objective Process Parameter Optimization for Energy Saving in Injection Molding Process

Modelling and simulation of moving interfaces in gas-assisted injection moulding process

Multi-Objective Optimization of Gas-Assisted Injection Molding by Considering of Gas Fingering Defect

EXPERIMENTAL INVESTIGATION ON GAS-ASSISTED CO-INJECTION MOLDING PROCESS

Process Parameters Optimization of Gas-assisted Injection Molding of Complex Shell Parts

3D Numerical Simulation of Gas-assisted Injection Molding

Experimental Study on the Influence of Gas Injection Controlling Parameters in a Gas Assisted Co-injection Molding Process

Hybrid optimization approach for gas-assisted injection molding based on metamodeling and particle swarm algorithm

Numerical Simulation of Moving Interfaces in Gas-Assisted Injection Molding Process by Level Set Approach

EXPERIMENTAL STUDY ON THE GAS ASSISTED CO-INJECTION MOLDING PROCESS OF POLYMER

Further Studies of the Gas Penetration Process in Gas‐Assisted Injection Molding

Numerical Simulation of Gas-Assisted Injection Molding Using CLSVOF Method

Research on Effect of Technological Conditions on Gas-Assisted Injection Molding Process

Dynamic Analysis on Gas-Assisted Injection Molding Process

Computer Simulation of the Filling Process in Gas‐assisted Injection Molding Based on Gas‐penetration Modeling

Surface Model Based Modeling and Simulation of Filling Process in Gas-Assisted Injection Molding

Filling simulation and gas penetration modeling for gas-assisted injection molding