Abstract:A finite element dynamic model of the sandwich composite plate was developed based on classical laminate theory and Hamilton's principle. A 4-node, 7-degree-of-freedom three-layer plate cell is constructed to simulate the interaction between the substrate, the viscoelastic damping layer, and the piezoelectric material layer. Among them, the viscoelastic layer is referred to as the complex constant shear modulus model, and the equivalent Rayleigh damping is introduced to represent the damping of the substrate. The established dynamics model has too many degrees of freedom, and the obtained dynamics model has good controllability and observability after adopting the joint reduced-order method of dynamic condensation in physical space and equilibrium in state space. The optimal quadratic (LQR) controller is designed for the active control of the sandwich panel, and the parameters of the controller parameters, the thickness of the viscoelastic layer, and the optimal covering position of the sandwich panel are optimized through simulation analysis. The results show that the finite element model established in this paper is still valid under different boundary conditions and different covering methods, and the model can still accurately and reliably represent the dynamic characteristics of the original system after using the joint step-down method. Under different excitation signals and different boundary conditions, the LQR control can effectively suppress the vibration of the sandwich plate. The optimal cover position of the sandwich plate is near the solid support end and far from the free-degree end. The parameters of controller parameters and viscoelastic layer thickness are optimized from several angles, respectively, and a reasonable optimization scheme can be selected according to the actual requirements.

Vibration Analysis and Structural Control of Oil Pan with Reinforcing Plate Based on Finite Element

Analysis and Controlling of Pipeline Vibration in Chemical Plant

Analysis on Vibration and Noise Reduction Mechanism of Thin-Wall Damping Parts

Analysis of Vibration and Radiated Noise Influenced by Reinforcing Plate in an In-Line 6-Cyilnder Engine

Building FEM Model and Structural Optimization for Oil Pan on HyperWorks

Numerical Analysis Of Noise Radiation Of Compressor Shell Considering Lubrication Oil

A Research on the Design of Low-noise Oil-pan Based on FEM and BEM

New modeling method for finite element analysis of large oil storage tanks

A Research on Prediction and Reduction of Radiated Noise from Oil Pan of Diesel Engine

Free Vibration Analysis of the Stiffened Plate

Research on vibration suppression of the Forklift Steering System based on finite element modal analysis and pole placement

ANALYSIS OF LATERAL VIBRATION OF A RECTANGULAR PLATE SUPPORTED AT FOUR CORNER POINTS WITH AN ADDITIONAL CONCENTRATED MASS BASED ON THE RAYLEIGH–RITZ METHOD

Research on Loudness of Radiation Noise of a Constrained-Layer Damping Oil Pan

Test Research on Active Vibration Control of Honeycomb Plate

Vibration control analysis of vehicle steering system based on combination of finite-element analysis and modal testing

Research on Prediction Method of Radiated Noise of Engine Oil Pan

Research on Vibration Properties of Finite Rib-Stiffened L-shaped Plate Using Wave Method

Structure Improvement of Oil Sump Based on Structural Sensitivity Analysis

Establishment of Approximate Analytical Model of Oil Film Force for Finite Length Tilting Pad Journal Bearings

Bending and free vibration analysis of sandwich plates with functionally graded soft core, using the new refined higher-order analysis model

Modeling and Vibration Control of Sandwich Composite Plates